Owner's Manual

CONTROL BOARD
The control board (Part #PU-CB98) is a digital read-out board. This board offers a wide
variety of settings to operate the unit. The bottom three control buttons are preset at the
factory and should not require any changes on start-up of the unit. This part can be removed
from the unit by loosening the two outside screws and pulling the board back to the inside of
the stove. The rear access panel should be removed prior to removing the control board. A
4-amp fuse is used on this control board.
THERMOSTATS
REMOTE: There is now a Remote Thermostat (Part # AC-3001) available for your pellet
stove. It comes with everything necessary for quick installation, and has many features to
allow remote control of your unit.
WALL: Also, an external wall thermostat (such as our Part # GU-1E30-914) can be used
on our pellet units as long as it is a 24-volt that works with millivolt systems. After unplugging
the unit, locate the jumper wire (J-3) on the bottom of the control panel. The two screws
should then be loosened and the jumper wire removed from the board. Next, the two
thermostat lead wires should be slipped into these openings and the screws tightened; the
jumper wire should be saved for future operation without a thermostat.
The unit will operate differently once the wall thermostat is connected -- we recommend the
stove control board be set at “9” on the Heat Range and Blower Speed while using the
thermostat. Refer to the section on “Start-up Procedure” for information on cold starts.
Call [phone] or log onto www.englandsstoveworks.com to inquire or order these.
ACCESSORY ITEMS
There are accessory items available for your stove, besides the wall thermostat (see
“External Thermostat” section). These accessories can be added to your unit at anytime;
however, let the stove cool down before adding the items.
AC-103 Brass Lip Trim
There is one piece of J-Channel trim in this kit that snaps onto the ash apron lip of the
stove. Match the channel with the correct edge, then remove the protective covering from
the trim and force the piece onto the edge. Although it should stay in place, stove cement
can be used to secure it if necessary. (NOTE: For stoves manufactured prior to 2001, the
part number for this kit is AC-101-PU.)
AC-106-P (SH-106-P) Brass Window Trim
This trim can be attached by using the spring clip and some high temperature silicone.
Insert the tee end of the spring clip into the opening on the edge of the trim -- this will allow
the clip to fall into the groove. The spring clip will hold well if it is placed on the bottom edge
of the trim. We suggest that high temperature silicone be used on the corners to ensure the
trim will stay in place.