Owner's Manual

ASH DISPOSAL

Regularly inspect the ash build-up in your unit and remove as necessary. Ashes can be removed

from the unit by shoveling them off the firebrick. This unit has an ash drawer plate (see Illustration 4)

that can be removed from the stove; once removed, the ashes can be raked through the opening and

into the ash pan.

Caution: The ash drawer plate can be extremely hot!! Never remove red-hot ashes from the

appliance; allow ashes to cool before dropping into the ash pan. Ashes should be placed in a metal

container with an airtight lid. The ashes should be placed on a noncombustible surface and

completely away from any combustible materials. The ashes should remain in the airtight container

until they have completely cooled.

DIRECTIONS FOR INSTALLATION OF

LEGS OR PEDESTAL:

(Stove must be cooled and all ashes cleaned out)

Remove bricks, disconnect flue, and turn stove on its

back.

* If you are replacing existing legs or pedestal,

disconnect the existing legs or pedestal.

To install legs:

1. Each leg will fit into a pre-made slot on each corner

of the bottom of the unit.

2. A 3/8” x 1-1/2” Carriage Bolt and matching nut is

supplied with each leg. Fit a leg into a slot, and

match the hole on the leg with the hole in the slot.

ttach the legs one at a time, using the supplied

bolts and nuts. Tighten securely.

To install pedestal:

1. Place spacers (provided) between the slots on the

unit and the pedestal base (one spacer will fit on

each side of the pedestal). Match the four holes in

the pedestal (2 on each side) with the holes in the

spacers and slots on the unit.

2. Use the four 3/8” x 1-1/2” Carriage Bolts and nuts

(provided) to attach the pedestal to the base of the

stove. Tighten securely.

fter attaching the legs or pedestal, turn unit upright,

reconnect flue and replace bricks according to

manual.

CONTROL SETTINGS

Burn Rate Inlet Air Setting

Low Fully Closed

Med. Low ¼ Open

Med. High ¾ Open

High Fully Open

Illustration 6 – Air Inlet Control