User guide

Enfora GSM1308 and

GSM1318

Quad-Band Spider®

SA-G+

User Guide P a g e 20 Revision: 1.03

Configure the SA-G+ to talk to the

Enfora Server

4. Connect and verify Serial connectivity with the Enfora SA-G+.

v. Connect the PC serial connector to the SA-G+ serial port.

Note: In the following instructions, <CR> means using the Enter Key

on the keyboard

With HyperTerminal open, hit the Enter key. The SA-G+ should respond with OK. If

you do not see this response, double-check your connections.

w. Type AT<CR>. The SA-G+ should respond with OK. If you do not see

the letters AT, send the following command to the SA-G+: ATE1<CR>

x. Type ATI<CR>. The SA-G+ should respond with Enfora, Inc. If you get

any different response, you are not connected to the Enfora SA-G+.