Installation Guide




Enclosed you will find everything needed for the
assembly and use of your storage rack. Two people
make assembly easier.
Hardware included:
16 – 5/16 " x 1/2 " Button Head Screws
1 – Hex key
Components included:
1 – Angled Corner Upright
2 – Straight Uprights
1 – 2 " Wide Corner Base Rim
3 – 1 " Wide Corner Shelf Rims
4 – Wood Shelves
ASSEMBLY INSTRUCTIONS

1) Lay out the components and hardware.
2) Working on the floor, take the upright with the angled corner and attach the 2 " wide base rim to
the bottom (it is the base of the stand) of the stand with two of the button head screws. Then attach
a 1 " shelf rim at the top of the Angled corner upright. Attach the remaining two 1 " center shelf
rims to the upright. Leave screws a little loose.

3) After all shelf rims are attached to the first upright, rotate the stand and attach the next upright to all 4
shelf rims. Rotate once again to attach the 3
rd
and final upright. Remove the protective ends from both
ends of all 3 uprights. Leave screws a little loose.

4) After standing it in an upright position, square up your stand and tighten your screws. Place the wood
shelves on the shelf rims.
5) That’s it! You are now ready to enjoy your new stand.
This rack is intended to be placed where it is out of the way of foot traffic and will NOT
be bumped or leaned on. Be sure it is against a wall, in a corner or otherwise placed
where it will not be bumped or hit. Heavier items should be stored at the bottom of the
stand. Boards are not intended to be used for outdoor use, trivets, serving platters, or cutting boards. They are
not food safe.











Warranty. This product is warranted to be free of material defects for a period of five years from the date of purchase.
Your exclusive remedy for breach of this warranty shall be the repair or replacement of the defective product when
delivered, postage prepaid, to Enclume Design Products at 24 Colwell St. Port Hadlock, WA. 98339. There is no other
warranty, expressed or implied, and there is specifically NO WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PORPOSE. In no event will Enclume Design Products be responsible for any incidental or consequential
damages related to use of this rack.
WARNING
Thank you for choosing Enclume!
Enclume racks are the ultimate in quality,
design, strength and function.

WARNING: READ ALL OF THE
INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR
RACK
If you need help, please call 1-877-362-5863 or
email [e-mail].
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Phone [phone]  Fax [phone]
www.enclume.com
CS4KD
Unassembled Corne
r
Stan
d
