Assembly Instructions

Page 1 of 2
ASSEMBLY & USE INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be followed including the following:
 The product is for indoor use only.
 To reduce the risk of fire, do not deliberately reposition either bulb or lampholder contact.
 To reduce the risk of overheating, replace burned out lamps promptly. This is an electrical product
- not a toy! To avoid the risk of fire, burns, personal injury, and electric shock it should not be
played with or placed where small children can reach it.
 Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use. When
products are used in outdoor applications, connect the product to a Ground Fault Circuit
interrupting (GFCI) outlet. If one is not provided, contact a qualified electrician for proper
installation.
 This seasonal use product is not intended for permanent installation or use.
 Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of
heat.
 Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
 Do not let lamps rest on the supply cord or on any wire.
 Unplug the product when leaving the house, when retiring for the night, or if left unattended.
 Do not use this product for other than its intended use.
 Do not hang ornaments or other objects from cord, wire, or light string.
 Do not close doors or windows on the product or extension cord as this may damage the wire
insulation.
 Do not cover the product with a cloth, paper or any material not part of the product when in use.
 The product employs overload protection (fuse). A blown fuse indicates an overload or short circuit
situation. If the fuse blows, unplug the product
from the outlet. Also unplug any additional
strings or products that may be attached to the
product. Replace the fuse as per the user
servicing instructions (follow product marking
for proper fuse rating) and check the product. If
the replacement fuse blows, a short circuit may
be present and the product should be
discarded.
Read and follow all instructions that are on
the product or provided with the product.
S
AVE THESE INSTRUCTIONS
ASSEMBLY INSTRUCTIONS:
1. Follow the stand assembly instructions to set
up the tree stand.
a. Pull apart the legs of the stand so that they are
X-shaped.
b. Screw the eye bolts through the hole of metal
tabs. Turn screws so they touch tree trunk.