Assembly Instructions

ASSEMBLY & USE INSTRUCTIONS
THESE INSTRUCTIONS ARE FOR YOUR SAFETY. READ AND
FOLLOW ALL INSTRUCTIONS AND WARNING LABELS BEFORE USING.
KEEP AWAY FROM WATER!
SAVE THESE INSTRUCTIONS!
CARE & USE
 Product is intended for INDOOR USE only. Do not use product
outdoors.
 Adapter is intended for INDOOR USE only.
 This power unit is intended to be correctly orientated in a vertical
or floor mount position.
 Do not mount or place the product near gas or electric heaters,
fireplaces, candles or other similar sources.
 Place the product on a flat surface so that the air vents in the base are
not blocked.
 Never place the product near a wet location.
 Keep the base of the product well ventilated. Do not cover the product
with cloth, paper or any material not part of the product when in use.
 Do not use with a voltage converter. Use only with the indoor adapter
that is provided.
 Do not leave the product unattended when children are present.
 Unplug the product when leaving the house, when retiring for the night,
or if left unattended.
 Never operate the product if it has a damaged cord or plug. In case the
external flexible cable or cord of the adapter is damaged:
DO NOT USE THE ADAPTER. DO NOT OPEN TO REWIRE!
THROW ADAPTER AWAY
 Do not use this product for any other purpose than its intended use.
 Not intended for permanent installation. Do not connected power
over than 24 hours continuously
 This is an electric product - not a toy! To avoid risk of fire, burns,
personal injury and electric shock, it should not be played with or
placed where small children can reach it.
BEFORE YOU START
* Check the carton; make sure you have all parts as listed below:
- Fiber Optic Tree
- Tree Base
- Adapter (UL listed )
IMPORTANT – Do not dispose the carton before you complete the assembly.
Detachable parts may be sitting there. Keep the package for storage
ASSEMBLY
1) Put the tree in the hole of the base.
2) Shape the tree by arranging the branches into the desired position.
Finished look should be natural looking and full.
3) Connect the cable connector on both base and tree.
4) Connect the product to the adapter.
5) Connect the adapter to a standard AC outlet.
6) Turn the tree on by sliding the switch at “ON” position.
7) The tree is activated to performance
TROUBLE SHOOTING
If the product is not activated, check these connections:
1) Make sure the switch is in the “ON” position.
2) Make sure the product is securely connected to the adaptor.
3) Make sure the adapter is securely connected to the power outlet.
If none of the above steps corrects your problem, please
contact the Customer Service Department at Puleo
International, Inc. following the steps as below:
FOR CUSTOMER SERVICE CALL: 1-800-311-3324
Business Hours: Monday - Friday - 9:30 am - 4:00 pm EST
BULB REPLACEMENT
Check the bulb located inside the base of the tree. Make sure the bulb
is properly seated in its socket. It may have loosened during transit.
Inspect the bulb. Check to see if it is damaged or burnt out.
Replace bulb with correct bulb size and voltage only. Failure to do so
may result in damage to the unit and may cause a fire.
The tree is equipped with a durable LED light set as light source, normally
it can works thousands of hours without failure, anyway, if the bulbs fails,
please contact above service call for a new one.
See next page