Measurement Guide

1234
Step 1 Step 2
Note
295cm
172cm
91
5
/16”
67
3
/4”
116
1
/8”
232cm
A
B
C
Centimeter Inches
1234
Each rubber liner can be reused up the 3 times.
*Make sure the mark is parallel to the edge
Measure the height of the installation
2-1 Measure the height of the installation. Measure
and mark the panel curtain at the desired height.
(a curtain weight can function as a straight edge).
1-1 Remove and discard the caps from the panel
curtains.
*To assist with installation, do not unfurl the curtains
until they are inserted into the slider.
1-2 Push the panel retaining gates on the sliders
up.
1-3 Insert the rubber liner part of panels curtain
into the sliders in the order shown below,
close the retaining gate, then furl the curtains.
Push Down
Close the gate
Push up
1-4 Push the tab on the end cap up to unlock,
remove the end cap, and insert the panel’s
rubber liner into the weight.
Open
Close
Remove
Pinch the weight
Panel Curtain Installation Customizing the Panel Curtain
Panel Curtain Installation Instructions
Panel
116
1
/8” panels come with
2-2 After cutting panel curtains to size with scissors
or a utility knife, remove the rubber liners from
the scraps. Staple the rubber liners onto panel
curtains.Space the staple 2 inches apart and
hammer the staples flat with a hammer.
About
4”