manual

3 | ENGLISH
Green & Yellow & Red flashing : sensor is in self-test mode this will take about 60
seconds. When self-test has finished all three LEDs will switch off.
* You can switch off the LED indicators by setting the LED jumper inside of the
EM8655 to the off position.
3.0 Inside the motion detector
Remove the back cover of the motion detector by unlocking it.
1. Microwave module 7. JP2 not used
2. Green LED 8. LED jumper
3. Red LED 9. Anti-tamper switch
4. Yellow LED 10. Microwave potentiometer
5. Infrared sensor (PIR) 11. Connection block
6. JP1 sensitivity jumper 12. Outlet
3.1 Group settings (jumpers)
Every sensor can be configured to be added to a dedicated group by setting the
jumper settings; home-group, normal group, single group or 24-hours group.
At default jumper D0 and D3 are set, this is equal to the normal group.
Bellow you will see an overview of the meaning and how to configure the jumper
settings for that type of zone.
Remark : Determine before pairing with the alarm system in which group the sensor
will be operational. Once the sensor is successfully paired with the system. The group
cannot be changed after pairing!