EM6610 e-Domotica Flush-Mounted Universal Dimmer 1-gang
| ENGLISH EM6610 e-Domotica Flush-Mounted Universal Dimmer 1-gang Table of contents 1.0 Introduction................................................................................................................. 2 1.1 Functions and features .......................................................................................... 2 1.2 Packing contents.................................................................................................... 4 2.0 How to install the dimmer.....................
| ENGLISH Caution! If you operate devices that do not correspond to the technical specifications (see technical data), you can damage the connected devices and the radio receiver. • Only connect luminaires to the dimmer. • Do not connect luminaires with energysaving lamp(s). • Do not connect combinations of electronic and conventional transformers • Only dimmable transformers may be connected.
| ENGLISH Figure 2 – Mounting the EM6610 1.2 Packing contents The following parts need to be present in the packing: • EM6610 e-Domotica Flush-Mounted Universal Dimmer 1-gang • Manual 2.0 How to install the dimmer Install the dimmer simply "invisibly" near the load to be connected, for example in a flush-mounted installation box with a blanking cover (Fig. 2) or ceiling junction box. Risk of fatal injury from electrical current.
| ENGLISH The fixing brackets or fixing screws of the blanking cover may also not press against the housing; if necessary, change the mounting position of the dimmer accordingly. Risk of fatal injury from electrical current. The outputs may carry an electrical voltage even when the dimmer is switched off. Always disconnect the fuse in the incoming circuit from the supply before working on connected loads. 1. 2. 3. Disconnect the circuit from the mains. Connect the dimmer as shown (Fig. 1): a.
| ENGLISH 8. 9. Give the connected and found device a name, choose a location and click ‘Save’. The dimmer has now been added to the e-Centre. The e-Centre will now be able to control the switch. 10. You can now put the dimmer into the junction box. We suggest to disable the mains by turning off the main switch of the house when putting the dimmer in the junction box. 4.
| ENGLISH 5.1 Resetting the dimmer to the factory settings (Reset) Under certain circumstances, it may be necessary to reset the dimmer to factory settings and to reconfigure: 1. 2. Press the dimmer's switch button three times within approx. 1.5 seconds (with an insulated tool such as an insulated phase tester; Fig.1E). The LED (Fig.1F) in the dimmer blinks. Then press and hold the switch button for approx. five seconds until the LED goes out. The dimmer has been reset to its factory settings.
| ENGLISH Country Belgium (Dutch) Belgium (French) Denmark Finland Germany Italy Norway Spain Sweden The Netherlands UK Phone number 070 277 286 070 277 286 +45 69918565 +35 8942415826 +49 (0)30 887 89 298 +39 0240042016 +47 21075033 807 080 042 +46 840 309985 0900-3646368 +44 (0)203 318 9998 Rate per minute* €0.30 €0.30 Local costs Local costs Local costs Local costs Local costs €0.41 Local costs €0.45 Local costs * Rates mentioned in this table do not include cell phone charges. 9.
| ENGLISH 10.0 Warranty conditions The five-year Eminent warranty applies to all Eminent e-Domotica products unless mentioned otherwise before or during the moment of purchase. When having bought a secondhand Eminent e-Domotica product the remaining period of warranty is measured from the moment of purchase by the product’s first owner. The Eminent warranty applies to all Eminent e-Domotica products and parts inextricably connected to and/or mounted on the main product.
