User manual

Accessing an RPC2 Communications Module via the Web Interface

Emerson

RPC2

™

To edit a branch:

1. Log in with the privileges required to change these settings.

2. From the PDU Explorer tab, click the rack PDU with the branch to be edited.

3. Highlight the branch to be edited by clicking in one of its fields.

4. In the table at the bottom of the page, click the Settings tab.

5. Check the box or boxes next to the settings to be edited.

6. Click the Edit icon .

7. Enter the new values or use a drop-down menu to enable or disable software overcurrent

protection or change whether the branch is designated critical.

8. When finished, click the Save icon, ✔, to make the change or click the Cancel icon to abort

the change. The icons will be in the column formerly occupied by the Edit icon.

4.5 PDU Explorer—Receptacle Information

Click on a branch in either the content area or from the navigation tree to display its receptacles.

Check the box beside the receptacles to be managed and use the icons at the top of the page to Reset

Energy, Enable Receptacle(s) Power, Disable Receptacle(s) Power, Cycle Receptacle(s) Power, Lock

Receptacle(s), Unlock Receptacle(s) or Blink Receptacle(s) LED.

The table at the bottom of the screen displays the selected receptacle's measurements, status, settings

and information.

NOTE

Clicking a branch will open its receptacle page.

Table 9 Receptacle summary descriptions

Item Description

Label Displays the receptacle name.

ID Displays the position of the receptacle on the rack PDU.

Type Displays the type of the receptacle.

Status Displays the status of the receptacle.

State Displays whether the receptacle is On or Off.

Lock Displays whether the receptacle is locked or unlocked.

Available Current Displays the available current for the receptacle.

Utilized Current Displays the current being used by the receptacle.

Utilization Displays percentage of the current being used by the receptacle.

Graphical Display

A graphical representation of the low current alarm threshold, over current warning threshold

and overcurrent alarm threshold.

Drop-Down Menus