Fan User Manual

housing assembly with the holes in the plate.
Secure the switch housing assembly by installing
the three screws (Figure 6).
8. Turn fan assembly upside down in preparation for
mounting fan blade assemblies.
9. Mount blade flanges to fan blades using three M5 x
6 washer head blade screws and three blade
washers (Figure 7).
NOTE: Take care not to scratch fan housing when
installing blades.
SWITCH
HOUSING
ASSEMBLY
MOUNTING
SCREWS (3)
FAN BLADE
BLADE FLANGE
M5x6WASHER HEAD BLADE SCREW (3)
BLADE WASHER (3)
SWITCH HOUSING
CONNECTOR
MOTOR CONNECTOR
SWITCH HOUSING
MOUNTING SCREW (3)
5 U.L. Model No.: CF755
Figure 5
Figure 6
To avoid possible fire or shock, do not pinch wires
between the switch cup assembly and the switch
cup plate.
Electrical Requirements
If your fan is to replace an existing ceiling light fixture,
turn electricity off at the main fuse box at this time and
remove the existing light fixture.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and
capable of withstanding a load of at least 50 pounds.
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
!
WARNING
!
WARNING
!
NOTE: Remove and discard the four shipping
spacers and screws from the motor hub.
10. Loosely attach one blade assembly to the motor
hub using two M6 x 14 captive screws with
lockwashers. Make sure the screws are NOT
tightened. (Figure 8.) Repeat this procedure for
other four blade assemblies.
11. The blade flanges have an interlocking feature
that must be fully engaged before tightening the
screw. Make sure all the flanges are properly
engaged and then tighten the flange screws. If
one of the flanges does not seat properly on the
motor hub, loosen the adjacent flange screws, re-
engage and reseat the flanges, then tighten the
screws again.
12. You have now completed the assembly of your
new ceiling fan. You can now proceed with
hanging and wiring your fan.
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
WARNING
!
BLADE
ASSEMBLY
M6 x 14 CAPTIVE
SCREWS WITH
LOCKWASHERS
Figure 8
Figure 7
To reduce the risk of fire, electrical shock, or
personal injury, mount fan to outlet box marked
“Acceptable for Fan Support”, and use screws
supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are not
acceptable for fan support and may need to be
replaced. Consult a qualified electrician if
in doubt.
WARNING
!