Operator`s manual

EN 37TROUBLESHOOTING
PROBLEM LIKELY CAUSE SOLUTION
check the tyre pressure (5.3.2)
realign the cutting deck to the ground
(6.3.2)
check that the blade is fitted properly
(6.3.1)
sharpen or fit new blade (6.3.1)
reduce forward speed and/or raise the
cutting deck (5.4.5)
wait for the grass to dry
remove the grass-catcher and empty
the collector channel (5.4.7)
clean the cutting deck (5.4.10)
balance or replace the blade if dama-
ged (6.3.1)
check that the blade is fastened pro-
perly (6.3.1)
check and tighten all the fixing bolts of
the engine and frame
cutting deck not parallel to the ground
blade cutting badly
forward speed too high compared to
height of grass
collector channel is blocked
cutting deck full of grass
blade unbalanced
blade loose
fixing bolts loose
9. Uneven cut and
poor grass collection
10. Unusual vibrations
while working
If problems continue after having carried out these operations, contact a Licen-
sed Service Centre.
Do not take on complicated repair work if you don't
have the necessary equipment and the technical knowledge. The guar-
antee is automatically revoked and the manufacturer declines all
responsibility for any bad repairs.
!
WARNING!