Operator`s manual

EN 33MAINTENANCE

4. check that the spring (7) of the engagement

cable is not too taut or too loose. Otherwi-

se, turn the adjusting nut (8) until the spring

reaches the right condition.

5. check the measurement of the spring (6)

again;

6. refit the collector channel (1), and always

put back the pin (2) and the split pin (3).

6.4 DISMANTLING AND REPLACEMENT

6.4.1 R

EPLACING WHEELS

1. Place the machine on a flat surface and

put blocks under a load-bearing part of

the frame on the side of the wheel to be

changed;

2. using a screwdriver, remove the snap ring

(1) and the washer (2);

3. pull out the wheel.

Smear some waterproof

grease on the axle and after refitting the

wheel, carefully refit the washer (2) and the snap ring (1).

Should you replace wheels or tyres, ensure that the right and

left wheels are of the same rolling diameter, and check that cutting deck is ad-

justed properly to prevent an uneven cut.

6.4.2 R

EPLACING AND REPAIRING TYRES

All puncture repairs or replacements will have to be carried out by a tyre repair

expert in accordance with the methods for the kind of tyre used.

NOTE

IMPORTANT