Installation Sheet

PAGE 5

4410BFFR_FTN_A LK4410BFFR_FTN_A

1000004253 (Rev. B - 03/20)

INSTRUCTIONS FOR CONNECTING TUBES FROM VALVE TO FOUNTAIN

Step 1 - Insert the 1/8” O.D. tube (Label A) into the connector (provided with fountain). Insert the 1/8” O.D. tube

coming from the fountain push button actuator into the connector. Trim any excess length.

Step 2 - Secure the 1/8” O.D. tube (Label C) to the waste line assembly. This line is a vent line and should be

open to the air.

Step 3 - Insert the 1/4” O.D. tube (Label E) into the 1/4” union (provided with valve assembly). Insert the 1/4” O.D.

water line coming from the fountain into union. Trim any excess length.

Step 4 - Insert the 1/4” O.D. tube (Label G) into the air gap assembly.

Step 5 - Secure the 1/4” O.D. tube (Label H) to the waste line assembly. This line is a vent line and should be

open to the air.

LABEL A

(ON/OFF CONTROL LINE

FOR BUBBLER ONE)

LABEL G (DRAIN LINE)

LABEL E (WATER LINE)

LABEL C (VENT LINE)

LABEL H (VENT LINE)

FOUNTAIN CONNECTIONS

FIG. 3

1/4" UNION (SUPPLIED WITH VALVE)

MALE CONNECTOR

(SUPPLIED WITH FTN.)

FOUNTAIN CONNECTIONS

PLUMBING CONDUIT

(BY INSTALLER)

TO VALVE