Installation Sheet

Page 5

LZO8*1H LZO8*2H LZO8*3H LZOD*1H

1000003484 (Rev. A - 07/18)

SNAP

ALIGNMENT

PEG

ALIGNMENT

NOTCH

REGULATOR

ASSEMBLY

Lower and Upper Shroud

To access the refrigeration system and plumbing connections, remove four screws from bottom

of cooler to remove the lower shroud. To remove the upper shroud for access to the pushbars,

regulator, solenoid valve or other components located in the top of the unit, remove lower shroud,

disconnect drain, remove four screws from tabs along lower edge of upper shroud, unplug two wires

and water tube.

Bubbler

To remove the bubbler, rst disconnect the power supply. The underside of the bubbler can be

reached through the access panel (Item 23, Page 2) on the underside of the upper shroud (Item 6).

Remove the access panel by removing the retaining screw. To remove the bubbler, loosen locknut

from the underside of the bubbler and remove the tubing from the quick connect tting per the

Operation Of Quick Connect Fittings section in the General Instructions. After servicing, replace the

access panel and retaining screw.

Service Instructions

FIG. 3

Sensor Eye

Adjustment Screw

FIG. 4

Basin

Locknut

BUBBLER DETAIL

NOTE:

When installing replacement bubbler and pedestal, tighten

locknut only to hold parts snug in position. Do Not Overtighten.