Installation Sheet

ManualsBrandsElkay ManualsDrinking FountainsElkay 36-5/16" Wall Mounted Bi-Level Drinking Station - Vandal Resistant Bubbler

Page 7

98957C (Rev. B - 2/13)

(L)VRCTL(R)8FR*1D (L)VRCTLFRDD*C

56305C

100806740570

101474551730

15009C

19037000

30664C

31490C

35839C

35768C

35900C

36322C

36173C

36167C

50986C

45866C

56092C

15005C

61313C

66703C

66810C

70002C

70009C

600985451640

28617C

28963C

22897C

45662C

45737C

75672C

100147140560

28596C

See Color Table

66743C

56237C

40045C

70018C

75524C

55996C

45736C

75570C

75661C

70864C

56033C

66576C

45929C

27124C

55931C

45876C

75583C

56121C

70682C

35906C

35907C

35909C

70432C

75506C

35902C

75588C

75589C

110868642550

160270508640

See Color Table

75520C

75523C

28551C

36012C

Gasket - Bubbler

Grommet - Compressor Mtg.

Stud - Compressor Mtg.

Nipple - Bubbler

Clip - Compressor Mtg.

Fan Blade

Fan Motor

Cold Control

Cover - Relay

Power Cord (RH Unit Refrig.)

Compressor Serv. Pak EMI 70

Overload

Relay

Holder - Regulator

Bubbler Assy.

Tubing - Poly (Cut To length)

Retaining Nut

Regulator

Drier

Evaporator Assembly

Screw - #10 x 1/2” Lg. HHSM

Screw - Fan Motor

Drain Plug 1-1/2

Screen - VR

Basin - Stainless Steel

Panel - Bottom Dispenser

Button - Push

Sleeve - Push Button

Cap Screw

Gasket - Drain

Panel - Screen

Panel - RH Rear

Panel - LH Rear

Panel - RH Dispenser Side

Panel - LH Dispenser Side

Panel - Dispenser Front

Panel - Front Lower

Condenser

Shroud Fan

Hex Nut

Hex Nut - Fan Blade

Clip (Front & Rear Panels)

Strainer (See “General Instructions”)

Half Nut - Regulator

Screw - #10 x .50 Pinned Torx

Screw - #8 x .50 Pinned Torx

Screw - #8 x .62 Torx/Slot

Washer

Heat Exchanger

Tube - Drain

Cover - Cold Control

Cover - Dispenser Bottom

Drain Tube Assy.

Elbow - 5/16” x 1/4”

Elbow - Drain

Tee 1/4

Heater Strip

Switch - Rocker

FR Thermostat Assy.

Screw - 8-32 x .38 THTC

Screw - #10 x .75 HHSM

Wire - Black #18AWG

Nut - Slip Joint 1-1/4”

Gasket

Screw - #10-24 x .75 Socket Hd.

Strainer - Bright

Panel - RH Rear TL

Panel - RH Rear TLR

Panel - LH Rear TL

Panel - LH Rear TLR

Torx Tool - T25

Torx Tool - T20

Hanger Bracket

Power Cord (LH/RH Units Less Refrig.)

PART NO.

DESCRIPTION

*REPLACE WITH SAME COMPRESSOR USED

IN ORIGINAL ASSEMBLY.

NOTE: All correspondence pertaining to any of the

above water coolers or orders for repair parts MUST

include Model No. and Serial No. of cooler, name and

part number of replacement part.

Sold Separate

ITEM NO.

115V PARTS LIST

PRINTED IN U.S.A.

ELKAY MANUFACTURING COMPANY • 2222 CAMDEN COURT • OAK BROOK, IL 60523 • 630.574.8484

REPAIR SERVICE INFORMATION TOLL FREE NUMBER 1.800.260.6640

FOR PARTS, CONTACT YOUR LOCAL DISTRIBUTOR OR CALL 1.800.323.0620

WARNING!

This unit is frost resistant down to 0

F with no wind.

Prevailing winds can reduce the ability of the heater

element to prevent light freezing. If the ambient air

temperature will drop below 0

F, the cooler needs to

be drained of all water by blowing out all water lines

and drain trap. A heater strip is used to heat the

unit and will begin to cycle at 40

+/- 5

F. A check

at this temperature will ensure the heater is working

and the unit is resistant to light freezing.

ALSO, MAKE SURE THERE ARE NO PLASTIC OR

FLAMMABLE COMPONENTS DIRECTLY ABOVE

THE HEATER STRIP.