Installation Sheet

ATTENTION INSTALLER:

1) ELKAY RECOMMENDS THAT DROP-IN/SELF RIM SINKS SHOULD BE INSTALLED BY A PROFES-

SIONAL EXPERIENCED INSTALLER.

2) ELKAY IS NOT RESPONSIBLE FOR SINK OR COUNTERTOP IF DAMAGED DURING INSTALLATION.

3) METAL EDGES MAY BE SHARP – USE CAUTION WHEN HANDLING.

4) FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES.

5) INSPECT SINK FOR DAMAGE PRIOR TO BEGINNING INSTALLATION.

INSTALLATION

1. Place sink upside down on countertop surface.

Place sink in exact position for installation and

pencil completely around sink to create a sink

outline.

2. Scribe actual opening 5/16" inside the sink out-

line, all the way around.

3. Cut out on inside of this line (following the man-

ufacturer’s instructions). If sink comes with a

faucet deck, install faucet to sink and tighten.

4. Apply a silicone sealer around entire perime

ter of

opening. Set bowl into opening.

INSTALLATION

5. Assemble screws into clamps. (Note: Screws are

designed to insert into clamps with backward

threading, so that in mounting, they will turn in

normal direction.) From underside of sink, place

one clamp near center of each channel, tighten

by hand enough to hold sink in place. This

applies to all sides. Space clamps as equally as

possible.

6. From the top si

de, check seal between rim

and countertop. Adjust clamps to high spot if

necessary.

7. Tighten clamp evenly with screwdriver in rotation

until sink is seated with countertop. Caution: Do

not overtighten clamps.

Installation Instructions

COUNTERTOP

SINK

SEALER

CLAMP

CHANNEL

SCREW

CLAMP DEVICE

PAGE 1
Installation Instructions 1) 2) 3) 4) 5) ATTENTION INSTALLER: ELKAY RECOMMENDS THAT DROP-IN/SELF RIM SINKS SHOULD BE INSTALLED BY A PROFESSIONAL EXPERIENCED INSTALLER. ELKAY IS NOT RESPONSIBLE FOR SINK OR COUNTERTOP IF DAMAGED DURING INSTALLATION. METAL EDGES MAY BE SHARP – USE CAUTION WHEN HANDLING. FOLLOW ALL LOCAL PLUMBING AND BUILDING CODES. INSPECT SINK FOR DAMAGE PRIOR TO BEGINNING INSTALLATION. INSTALLATION INSTALLATION 1. Place sink upside down on countertop surface.
PAGE 2
Installation Instructions Suggestions for the Care and Cleaning of Sinks made with CuVerro® Antimicrobial Copper ELKAY SATIN FINISH Elkay's original highlighted satin finish is produced by an abrasive grinding operation which lends a uniform pattern of satin finish lines to the metal surface. All exposed areas then undergo a series of progressive machine and hand polishing operations. It is this careful polishing that makes an Elkay satin luster finish so beautiful…and so easy to clean and maintain.