Installation Guide

1. Carefully orient, mount and
hand tighten the faucet to the
two flanges. Be sure to include
the washers provided.
2. Use wrench to tighten flange
against backsplash. (Maintain
alignment of faucet or spout to
sink while tightening.)
3. Wrench tighten flanges to
faucet body, tighten flange
against backsplash.
4. Make sure drain is attached
and turn on water supply –
being sure to check for leaks.
Wrench tighten where needed.
5. For Model LK907B0BC08H,
the support bracket may either be placed above or below the faucet (see
Figure 3). After installing the faucet, place wall bracket against wall for location
of the proper anchors and fasteners.
APPROX.
15-1/4"
WALL BRACKET BASE
ATTACH WITH SCREWS
(NOT INCLUDED)
Assemble Faucet to Flange
FIGURE 3
1. Prior to spout installation remove pr
ovided lock pin from sealed bag.
2. Place lock pin in the pierced hole at the base of the spout.
3. Align pin with slots in the ring found inside the throat of the spout connection on
the faucet body.
4. Tighten spout nut to appropriate torque.
TO FIX SPOUT IN POSITION