Installation Instructions

Page 13 1000001734 (Rev. C - 11/14)

EZWSR*1C, *2C LZWSR*1C, *2C

Bottom View of Cooler

Fig. 13

Alternate Filter Mounting Location Fig. 14

3/16” Dia.

2 Holes

EXISTING

HOLE

1-3/8” Dia. Hole

SCREWS

PLASTIC BUSHING

SCREWS

FILTER MOUNTING BRACKET

FILTER ASSEMBLY

ALTERNATE FILTER MOUNTING LOCATION

1) Using the supplied punch from the Bottle Filler installation, punch a 1-3/8” dia. hole “A” at the existing hole shown in

Fig. 13.

2) Drill two 3/16” dia. hole at location “B” shown in Fig 13.

3) Remove Filter bracket from lter assembly and reinstall as shown in Fig. 14. Be sure the 3/8” water inlet is facing out.

4) Install plastic bushing (supplied) as shown into 1-3/8” hole, bushing must be used so waterlines will not be cut by

sharp edges of base plate.

5) Install lter assembly to bottom of cooler as shown in Fig. 14 with 2-#8 sheet metal screws.

6) Run the inlet and outlet water lines to lter.

7) P/N 98551C - LZ Filter Mounting Cover (Light Gray Granite) or P/N 98568C - LZ Filter Mounting Cover (Stainless Steel)

may be order to enclose the lter beneath the cooler (Not Shown).

3/8” WATER INLET