Installation Sheet

4. Install soap spout to sink wall. (Optional – only if soap dispensing option ordered).
Remove the nut from the spout. Feed the spout through the 3/8” hole from the back side. Reinstall the nut and tighten
appropriately. Push one end of the included tube over the back spout opening. Use pliers to slide a clamp over the end of the
tube. Allow the tube to dangle until subsequent steps.
5. Attach water lines.
Attach flexible supply lines (not supplied) to the H and C
ports of the thermostatic mixing valve (Ensure included
screen/gaskets are inserted into the inlets) and tighten appropriately. Attach a 36” ½” FIP line (supplied) to the output of the
thermostatic mixing valve and tighten appropriately. Attach a 36” ½” FIP line (supplied) to the bottom of the spout and tighten
appropriately. Allow lines to dangle until subsequent steps.
6. Mount sink.
Attach the mounting bracket to the wall using the rough-in diagram (Included). Hang the sink on t
he bracket and make sure
that it seats completely. Fasten sink to wall using the wall anchor points.
7. Attach the water switch.
Using tape or pipe dope, attach ½ FIP nipples to the input and output of the water switch. Attach the hose from the output of
the thermostatic mixing valve to the side input of the water switch. Attach the hose from the spout to the rear output of the
water switch. Attach supply lines to supply stops. Loosen the nut on the plunger end of the water
switch. Slide the switch into
the bracket with the hose pointing to the left. Tighten the nut down to hold switch in place.