Installation Guide

INSTALLATION INSTRUCTIONS
CAULKING
COMPOUND
COUNTER TOP
SINK
UNDER SIDE OF SINK
COUNTER TOP
DRAW OUTLINE
AROUND SINK
5/16 MINIMUM
OUTLINE OF
SINK
COUNTER TOP
COUNTER TOP
1 Position sink upside
down on countertop.
2 Draw line 5/16” inside outline of sink.
3 Cut on inside line. Cut straight front-to-back
and left-to right.
4 Apply caulking compound around cutout on
countertop top surface.
5 Mount faucet and drain(s) in place on sink and
tighten per manufacturer’s instructions.
6 Set sink in cutout.
7 Preassemble clamps, screws and plastic pads.
8 From underside – place clamp in center along
each side and hand tighten to hold sink in place.
Fasten balance of clamps along edges spaced
approximately 3” from each end, and equally along
front, back and sides.
For countertops thicker than 3/4”
up to 1-1/2”, Elkay recommends using LK364.
9 From the top – check seal between sink edge
and countertop. Adjust clamps if necessary.
10 Lightly tighten clamps evenly with screw driver
or socket wrench until sink is perfectly tight to
countertop.
CAUTION: Do not over tighten.
DETAIL OF U-CHANNEL
MAXIMUM CUTOUT SIZES SHOULD BE:
Sink Size Cutout Size
Cutout
Corner
Radius
33" x 22" 32-3/8" x 21-3/8" 1-1/2"
25" x 22" 24-3/8" x 21-3/8" 1-1/2"
17" x 21" 16-3/8" x 20-5/8" 1-1/2"
17" x 19" 16-3/8" x 18-3/8" 1-1/2"
15" x 15" 14-3/8" x 14-3/8" 1-1/2"
Sink
Screw
(Optional: LK364)
Clip
Silicone Caulk
(Not Furnished)
Countertop