Installation Guide

WIDTH
LENGTH
1/4" RADIUS ON
ALL4CORNERS
DAYTON UNIVERSAL MOUNT
STAINLESS STEEL SINK
INSTALLATION
1. Place sink upside down on countertop surface. Place sink in exact position for installation and trace completely
around sink to create a sink outline.
2. Scribe actual opening 5/16" inside the sink outline, all the way around.
3. Cut out on inside of this line (following the manufacturer’s instructions). Install faucet to sink and tighten.
4. Apply a silicone caulk around entire perimeter of opening. Set bowl into opening.
5. From underside of sink, place one clamp near center, tighten by hand enough to hold sink in place. This applies to
all four sides. Fasten balance of clamps in position and hand tighten. (Usually 3 clamps on end, balance divided
equally front and back). Space clamps as equally as possible. For countertops thicker than 3/4” up to 1-1/2”, Elkay
recommends using LK364.
6. From the top side, check seal between rim and countertop. Adjust clamps to high spot if necessary.
7. Tighten clamp evenly with screwdriver or socket wrench in rotation until sink is seated with countertop.
Caution: Do not over-tighten clamps.
II. TOP MOUNT INSTALLATION
Installation Profile
Sink
Screw
(Optional: LK364)
Clip
Silicone Caulk
(Not Furnished)
Countertop