User's Manual

Including Sensor (mouse zapper) to Z-Wave Network
The mouse zapper can be included to the Z-wave network by pressing the code button.
1) Disassemble the mouse zapper and insert the battery. Make sure the device locates
within the network range of the Z-wave main controller.
2) Set the Z-wave main controller in the learning mode (see main controller’s
operating manual).
3) Quickly, triple click the code button, LED diode will flash.
4) Mouse zapper will be detected and included in the Z-Wave network.
5) Wait for the main controller to configure the mouse zapper.
Excluding Sensor (mouse zapper) from Z-Wave Network
1) Make sure the sensor is connected to power source.
2) Set the Z-wave main controller into the learning mode (see main controller’s
operating manual).
3) Quickly, triple click the code button,LED diode will flash 5 times.
4) Wait for the Z-wave main controller to delete the sensor.