User's Manual Part 1

43 MEGAM.O.L.E.® Help System Guide
16) Unwind the sensor leads and attach the connectors to the M.O.L.E. Profiler.
Make sure to connect them to the same channel(s) that were configured in the
wizard workflow. For example, if configuring the M.O.L.E. Profiler to have
Channels 1 through 5 active, be sure the sensors are attached to the same five
channels.
Kapton® tape, aluminum tape and Temprobe™ can also be used to hold T/C
wire to the test assembly.