User Manual

17
OPERATING INSTRUCTIONS (CONTINUED)
Correct cookware position:
To use this mode you have to place the cookware on the
four connected sections. If you use cookware smaller than
three sections the display shows
and after 2 minutes
the zone switches off.
Incorrect cookware position:
Powerslide Function
This function allows you to adjust the temperature by
moving the cookware to a different position on the
induction cooking area.
The function divides the induction cooking area into
three areas with different heat settings. The hob senses
the position of the cookware and sets the heat setting
corresponding with the position. You can place the
cookware in the front, middle or rear position. If you
place the cookware in the front you get the highest heat
setting. You can decrease the heat setting by moving the
cookware in the middle or to the rear position.
IMPORTANT!
Use only one pot when you operate the function.
General information
• 160 mm is the minimum bottom diameter of the
cookware for this function.
• Heat setting display for the left rear control bar
shows the position of the cookware on the induction
cooking area. Front
, middle , rear .
• Heat setting display for the left front control bar
shows the heat setting. To change the heat
setting use left front control bar.