User Manual

2
- CONTROLS, INDICATORS & I/O-
The following descriptions detail all of the sliders, switches, LEDs (lights)
and I/O jacks on the CLOCKWORKS:
CH 1-4 DIVISOR Sliders & LEDS
Each channel has its own independent DIVISOR slider control. Set a
given channel’s clock divider by moving the center of its DIVISOR slider
to the number you wish to divide by. For example, if you want Channel 2
to divide the master clock by 3, set the CH 2 DIVISOR to 3, centering the
slider on the mark for 3.
Above each DIVISOR slider is an LED. The LED blinks each time the
channel sends out its clock pulse.
CH 1-4 LEVEL Sliders
Each channel has its own independent output LEVEL control. The LEVEL
slider sets a given channel’s output pulse amplitude or level. The
maximum output pulse level is 10Vpp. The pulse waveform ranges from
0V to +10V, it does not go below 0V. As you bring the LEVEL sliders
down, the amplitude decreases to 0V.
HOW TO SET THE LEVEL CONTROL:
Start with the LEVEL control at its bottom position. Move the LEVEL
control upwards while listening to or watching the slave device to which
the channel is connected. At lower LEVEL settings the slave device might
not be triggered at all or by only every other pulse from the Clockworks.
Push the LEVEL control up until each pulse from the Clockworks triggers
the slave. Once you reach this position, push LEVEL up a little bit more
and then stop. The LEVEL control is now set.
OUT 1 - OUT 4 Output Jacks
Each clock divider channel has its own independent output jack. CH 1
connects to OUT 1, CH 2 to OUT 2, etc. The level of the pulse at each
output jack is controlled by its channel’s LEVEL slider. These jacks are
mono/TS ¼” jacks; insert any standard patch or instrument cable into
the jacks.