USER MANUAL PREMIUM DEHUMIDIFIER WITH DIGITAL HUMIDISTAT WITH AIR PURIFIER, UV AND PLASMA IONISER AND SMART WIFI APP CONTROL CD25PRO-LE-V2 - 25L Litres per day Thank you for choosing electriQ Please read this user manual before using this innovative Dehumidifier and keep it safe for future reference Visit our page www.electriQ.co.
CONTENTS SAFETY INSTRUCTIONS 3 ENERGY SAVING 5 INSTALLATION 6 FEATURES 6 PARTS 7 CONTROL PANEL 8 QUICK REFERENCE GUIDE 10 OTHER FEATURES AND INDICATORS 12 POSITIONING THE DEHUMIDIFIER 13 WATER DRAINAGE 14 SETTING UP THE WIFI 16 CONTROLLING YOUR DEVICE THROUGH THE APP 21 CARE AND MAINTENANCE 26 FREQUENTLY ASKED QUESTIONS 27 TROUBLESHOOTING 28 TECHNICAL SPECIFICATION 29 SUPPORT 29 2
SAFETY INSTRUCTIONS IMPORTANT • Carefully read the instructions before operating the unit. • This appliance is only intended for use in an indoor domestic environment. Any other use is not recommended by the manufacturer and may cause fire, electrical shock or other injuries to person or damage to property. • Rating: This unit must only be connected to an AC 220-240V / 50 Hz earthed outlet. Installation must be in accordance with the regulations of the country where the unit is used.
• A damaged power supply cord should be replaced by the manufacturer or a qualified electrician in order to avoid a hazard. • Any service other than regular cleaning or filter replacement should be performed by an authorized service representative. Failure to comply could result in a voided warranty. • Do not use the appliance for any purpose other than its intended use. • Do not tilt the unit while in use. The unit is designed to work only in a vertical position.
ENERGY SAVING AND UNIT SAFETY PROTECTION TIPS • • • • • • Do not cover or restrict the airflow from the outlet or inlet grills. For maximum performance, the unit should be operated at least 20 cm away from walls and 50 cm from other objects within the room. The minimum room size for operation is 5m2 . Keep the filters and grills of the appliance clean. Under normal conditions, filters and grills should only need cleaning once every three weeks (approximately).
INSTALLATION Remove any water from within the water tank before starting the unit. In order to save energy do not open windows or doors while the unit is running. Place the unit on a hard / flat surface. On first use run the unit continuously for 24 hrs. TO REDUCE NOISE LEVELS Place a piece of carpet or a rubber mat under the unit to reduce any vibrations while the unit is running. The dehumidifier uses compressor technology to extract water from the environment.
PARTS Handle Louvres Air Outlet Castors Power Cord Control Panel Pre-Filter / Activated Carbon Filter (Optional) Continuous Drainage Port Water Tank ACCESSORIES Activated carbon filter (Optional) HEPA FILTER 6 stage dual action dehumidifier and purifier great in improving indoor air quality 7
CONTROL PANEL POWER POWER BUTTON Turns the appliance on/off MODE BUTTON Select the function of the unit between SMART / HIGH / LOW / and Air Purifier. The LED’s next to the button will show which mode is selected. SMART MODE: The unit will default to SMART mode the first time it is switched on and remains in this mode until another program is chosen. In smart mode, it will aim for a relative humidity of 50-55%, and the fan speed will be adjusted automatically.
WIFI BUTTON Press and hold the WIFI button for 3 seconds to activate the WIFI connection mode. The WIFI indicator light will be illuminated. See the WIFI guide within this manual for further information on how to set it up. HUMIDITY SETTING Press the UP and DOWN buttons to select the desired relative humidity level. The default relative humidity is 55%. When a relative humidity of 35% is selected, the compressor will not stop until the water tank is full.
QUICK REFERENCE GUIDE POWER POWER BUTTON: Press to turn the unit ON/OFF. OSCILLATION BUTTON: Press once to make the louvre swing and press again to lock at 45 degrees, press again to lock at 90 degrees. Do not operate the unit if the self-opening louvers do not open on power on.
LAUNDRY MODE When drying clothes, it is advised for the dehumidifier to operate continuously with maximum water extraction until the water tank is full. Set the unit to the High mode, and set the desired humidity level between 35%-50%. 35% is very dry and is hardly achievable in a UK domestic environment. As such the unit will work until the water tank is full when set to 35%. Set the louvres to swing mode or to 45 degrees directing the airflow onto the clothes.
OTHER FEATURES AND INDICATORS TANK FULL LIGHT When the water tank is full, removed or incorrectly inserted the unit will stop dehumidifying, the red tank full light will illuminate and the unit will beep. Empty the tank and reinsert it correctly to resume operation. AUTO DEFROST When frost builds up on the evaporator coils, the compressor will cycle off and the unit will go in to defrost mode. Following completion of the defrost mode, the unit will return to the previously operating settings.
POSITIONING THE DEHUMIDIFIER A badly positioned dehumidifier will have little effect. When positioning the dehumidifier please ensure circulation of air is not restricted around the unit. Allow at least 20 cm of space around the unit. This dehumidifier is designed only for indoor residential or small office applications and any commercial or industrial use will invalidate the warranty. Use in an enclosed area for maximum efficiency. Close all doors and windows to create an effective operating environment.
WATER DRAINAGE When the water tank is full, the unit will stop automatically. When this happens the TANK FULL red light will show on the control panel, and the unit will bleep. There are two ways to dispense collected water. It can be either collected within the internal tank or expelled through a drainage hose (supplied) using continuous drainage. USE THE TANK When the tank is full, the unit will automatically stop running, and the Tank Full indicator light will flash.
CONTINUOUS DRAINAGE This dehumidifier has a continuous drain hole that can be connected to a plastic pipe with a 15 mm inner diameter (Not Supplied). Water can be automatically plumbed in or drained into a sink, a larger receptacle or through the wall into an outside drain. Please follow the steps below to set your unit up for continuous drainage. 1. 2. 3. Cut off the cover for the continuous drain on the back of the unit.
SETTING UP THE WIFI APP This is designed as a general guide to the setup. There may be differences in the interface and features available due to product development and features of the model. BEFORE YOU START • Ensure your router provides a standard 2.4ghz connection. • If your router is dual-band ensure that both networks have different network names (SSID). The provider of your router / Internet service provider will be able to provide advice specific to your router.
REGISTER THE APP 1. Press on the register button at the bottom of the screen. 4. A verification code will be sent by the method selected in step 3. Enter the code into the app. 2. Read the Privacy policy and press the Agree Button. 5. Type in the password you would like to create. This needs to be 6-20 characters, with letters and numbers. 17 3. Enter your email address or phone number and press continue to register. 6. The app is now registered.
SETTING UP YOUR HOME WITHIN THE APP TUYA is designed so it can work with a large number of compatible smart devices within your home. It can also be set up to work with multiple devices within different houses. As such, during the setup process the app requires that different areas are created and named to allow easy management of all your devices. When devices are then added, they are assigned to one of the rooms you have created. CREATING ROOMS 1. Press on the ADD HOME button. 2.
CONNECTING USING QUICK CONNECTION Before initiating the connection, make sure the unit is in standby mode, with the WIFI light flashing twice per second. If not, follow the instructions for changing the connection mode. Ensure your phone is connected to the WiFi network. (We advise turning mobile data off during setup) 1. Open app and press “+” to add device, or use the add device button 4. Enter your WiFi password and press confirm. 2.
CONNECTING USING AP MODE (ALTERNATIVE METHOD) Before initiating the connection, make sure the unit is in standby mode, with the WiFi light flashing once per second. If not, follow the instructions for changing the connection type. Ensure your phone is connected to the WiFi network. (We advise turning mobile data off during setup) 1. Open app and press “+” to add device, or use the add device button 4.
CONTROLLING YOUR DEVICE THROUGH THE APP THE HOME SCREEN Add a device Choose the device to control Smart Scenes / Automation User Profile DEVICE SCREEN ON / OFF Button: Use to quickly turn the unit on or off.
DEVICE SCREEN The device screen is the main control screen for the dehumidifier, providing access to the controls to amend the functions of the dehumidifier Profile: Use to change the name of the dehumidifier and amend user settings.
SMART SCENES Smart Scenes is a powerful tool providing the option to customise the operation of the dehumidifier based both on conditions within the room and outside influences. This gives the user the option of specifying much more intelligent actions. These are split into two categories Scene and Automation. SCENE Scene allows for a one-touch button to be added to the Home screen. The button can be used to change a number of settings in one go and can change all the settings within the unit.
AUTOMATION Automation allows an automatic action to be set up for the device. This can be triggered by the Time, indoor temperature, humidity of the room, weather conditions, and a range of other influences. 1. Press on the Smart Scene tab at the bottom of the Home screen 2. Press on the Plus in the top right corner to add a smart scene. 4. Setup is very similar to the scene setup on the previous page, and includes an extra section for specifying a trigger for the scene to start. 3.
DEVICE DETAILS SCREEN The device details screen gives you the option to edit the details for the device, and use some of its additional features. The device details screen can be accessed from the device screen by pressing on the symbol in the top right hand corner. CHANGING THE NAME OF YOUR DEVICE The top option within this allows you to change the name of the device to something relevant to the use of the product, such as “Living Room Dehumidifier”.
CARE AND MAINTENANCE Always shut off the unit and unplug it from the mains before cleaning or performing any maintenance. When it is not in use for long periods, it is advisable to remove the plug from the power socket. Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible damage to the unit. FILTER CLEANING The Air-inlet may gather dust easily, please clean it often with a soft, damp cloth.
FREQUENTLY ASKED QUESTIONS Why doesn't the dehumidifier seem to extract much water if the temperature is low? This is a compressor dehumidifier which works best in temperatures above 15 oC. If the temperature is low and the air is dryer than the setting on the humidistat the unit will not extract water. If you want to use a dehumidifier for outside buildings, unheated properties, boats or garages please check our desiccant range.
TROUBLESHOOTING ISSUE CAUSE Hot or cold air being produced Normal Operation Unit does not operate Front louvres do not open Dehumidifier does not extract water Airflow seems weak Unit is noisy during operation Is the plug properly inserted in the socket? Does the tank full indicator is red? Louvre motor is blocked Is the unit set to a humidity level lower than the one in the room? Is the temperature too low for water extraction to be efficient? Is any intake grill or discharge blocked? Is the unit t
TECHNICAL SPECIFICATIONS Model Voltage Dehumidifying capacity Fan Speeds Power Consumption Running Amps Tank Capacity Humidity settings range IP RATING Refrigerant Airflow High / Low Pressure Max noise level Filters Dimensions mm (WxHxD) Weight GWP CD25PRO-LE-V2 1Ph, 220-240V~ 50Hz 25 L / day (at 30oC / 80%RH) 2 320W 1.72 Amps 5 litres 35%~80% IPX1 R290, 95 grams 210 m3/h 3.2/0.7MPa 48 dB(A) carbon (optional) 400 x 625 x 220 mm 17.5 kgs 3.3 electriQ UK SUPPORT www.electriQ.co.
