User's Manual

ENG man BRAVO-FUNK-915 00 BRAVO-FUNK-915 Radio remote control system
- Page 7 -
ENGLISH
Before proceeding with any kind of maintenance make sure the receiver is not powered, that the transmitter is switched
off and the emergency STOP button pressed.
In the event it is necessary to intervene on the machine or on the receiving unit for maintenance operations, electrically
disconnect the receiver unit from the machine.
Even though the radio remote control system does not require special maintenance operations, some precautions are
nevertheless necessary so that it remains fully efcient at all times.
Controls to be carried out daily before using the Radio remote control:
- Check that all the command symbols are clearly visible.
- Check that the mushroom Stop pushbutton works properly: the pressure exerted on the button must not be high and
the reset must take place without friction or forcing.
- With the mushroom button pressed, press the Start command. The red Battery Check LED must switch on.
- Check the integrity of the transmitter's plastic casing. It should not have cracks.
- Check the integrity of the rubber of the command actuators (joysticks, toggle switches, pushbuttons, etc.). It should
not have cracks or holes.
- Once you have nished using it, remove any deposits and clean it with a cloth.
Controls to be performed weekly:
- Clean the transmitter with a damp cloth and verify its integrity.
- Clean the springs of the battery holder and of the batteries.
- Clean the springs of the battery holder placed on the battery charger.
- Check the integrity of the receiving unit. The casing should not have cracks.
Controls to be performed monthly:
- Clean the receiving unit with a damp cloth and assess its integrity.
- Check the connection of the antenna on the receiver.
Controls to be performed yearly:
- Open the receiving unit and verify the integrity of the internal components. There should be no residual moisture
or oxidation.
- Check the integrity of the receiving unit's gasket on the cover.
- Check cable seal.
- Fully recharge the batteries in the event of prolonged disuse of the system.
In addition to the above recommendations, in order to maintain the efciency of the radio remote control System, the
following precautions should be carried out:
- Protect the transmitting unit from jets of water or rain.
- Remove the receiving unit if it is installed externally during transport. In case of rain during transport, the receiving
unit's IP level may not be sufcient to prevent water seepage, if it is directly exposed to the rain.
- Do not leave the transmitter unnecessarily exposed to direct sunlight or heat sources.
Should it be necessary to send the Radio Remote Control system to a service center to have it repaired, it is important to
send the Transmitter along with the Receiver. Only by doing so can we guarantee the System will be certainly repaired
and returned fully functional. Contact the service center in advance before proceeding to send the material and include
a description of the abnormal condition encountered in the packing or in the waybill.
2.6 MAINTENANCE