Installation Guide

METAL BRACKET
installation instructions:
electric drill
screws
level
pencil
shims
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• It is highly recommended that you paint/nish our steel brackets before you install them.
• Once installed, you can apply any necessary touch‐up paint/nish..
• Make sure that the surface and the back of the bracket are completely clean & dry before attempting installation.
• Measure and mark the location where the bracket is going to be installed and be sure that the bracket has a
substructure with a minimum 3/4” thickness.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
Consult a professional when installing brackets for load bearing applications
1. Paint or nish your bracket.
2. Be sure that the installation area is supported by a substructure with a mini-
mum of 3/4” thickness.
3. Place the bracket in place, check that it is level, and mark its position with a
pencil.
4. If the angle of your installation area and bracket do not match use shims to
adjust the angle.
5. Fasten the bracket in place with screws and check that it is level.
6. Touch up the bracket with touch up paint as needed.