Installation Guide

BRACKETS & CORBELS
installation instructions:
construction adhesive
elastomeric adhesive caulk
caulking gun
nail gun
nishing nails
extra ne sandpaper
putty knife
TOOL & MATERIAL
CHECKLIST
IMPORTANT INFO
• It is highly recommended that you paint/nish our brackets or corbels before you install
them.
• Once installed, you can apply any necessary touch‐up paint/nish.
• Clean installation surface and back of bracket of all dirt and dust with a clean cloth or
sponge.
• Make sure that the surface and the back of the bracket are completely dry before at-
temptinginstallation.
• Measure and mark the location where the bracket is going to be installed.
SAFETY INSTRUCTIONS
Make sure to use the correct tools recommended.
Wear safety goggles.
Follow xture, power tools, and paint manufacturers’ instructions and users manuals.
Use common sense and follow good construction practices.
Brackets & Corbels are not load‐ bearing.
1. Lay the bracket or corbel face down on a soft surface that will not scratch/
dent the bracket detail.
2. Apply a 1/2” bead of adhesive caulk all the way around the back edge of the
bracket.
3. When pressing the bracket up against the surface, some adhesive caulk will
seep out. Smooth excess caulk around the bracket with a nger or the putty
knife and apply extra caulk that is needed to ll in any gaps.
4. Wipe off any excess adhesive caulk with a sponge or damp rag.
5. Finishing nails may be used for added support. If used, ll in any nail holes
with caulk and smooth the surface with a nger. Let any excess caulk dry.
Once dry, lightly sand with extra ne sandpaper.
6. Touchup bracket with touchup paint as needed