Drawing : - TPC474 Issue :-2 Date : - 11/04/19 BD75 INDUSTRIAL DEHUMIDIFIER OWNER’S MANUAL www.eipl.co.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 INTRODUCTION Designed for a wide range of applications, the RM75 is a rugged, industrial unit, which utilizes an energy-efficient compressor and a compact portable design to provide easy efficient drying. The fan draws the moist air through the cold evaporator coil, which cools the air below its dew point. Moisture forms on the evaporator coil and is collected in the condensate tray, which is equipped with a permanent drain.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 SPECIFICATIONS MODEL: 10224GG-GB HEIGHT: 615 mm WIDTH: 382 mm DEPTH: 365 mm WEIGHT: 26 kg AIRFLOW: 185 M3/Hr POWER SUPPLY: 230V/ 50Hz/ 1 ph FINISH: Rotational Moulded polyethylene OPERATING RANGE: 3°C – 35°C REFRIGERANT: R410a (140g) "This product contains fluorinated greenhouse gases covered by the Kyoto Protocol. The refrigeration system is hermetically sealed.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 OPERATION After unpacking, examine all external features to confirm damage-free shipment. Report all defects and damage at once. Connect to a grounded 13A electrical outlet. To protect the compressor, you should allow 5 minutes between switching the dehumidifier off and on again. PERMANENT DRAINAGE For this you will need a length of PVC tubing 10mm internal diameter. Disconnect your dehumidifier from the power supply before fitting permanent drainage tube.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 ROUTINE SERVICE WARNING: ENSURE THAT THE POWER CORD TO THE MACHINE HAS BEEN DISCONNECTED BEFORE CARRYING OUT ROUTINE SERVICE. THE SERVICING AND REPAIR OF THIS UNIT SHOULD ONLY BE CARRIED OUT BY A SUITABLY QUALIFIED PERSON. To ensure continued full efficiency of the dehumidifier, service procedures should be performed as follows: 1. Clean the surface of the evaporator and condenser coils by blowing the dirt out from behind the fins with compressed air.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 REPAIRS 1. Should an electrical component fail, consult the Factory Service Center to obtain the proper replacement part. 2. If refrigerant gas is lost from the machine, it will be necessary to use a refrigeration technician to correct the fault. Contact the Factory Service Center prior to initiating this action. Any competent refrigeration technician will be able to service the equipment. The following procedure must be used: a.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 TROUBLESHOOTING SYMPTOM CAUSE Unit inoperative 1. No power to unit 2. Mains cable damaged. Little or no airflow 1. Fan motor burnt out 2. Dirty refrigeration coils 3. Loose electrical wiring Little or no water extraction 1. Insufficient air flow 2. Compressor fault 3. Loss of refrigerant gas Little or no defrost when required 1. Faulty timer 2. Faulty by-pass valve Unit vibrates excessively 1. Loose compressor 2.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 RM75 SPARE PARTS LIST NUMBER 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 DESCRIPTION Timer Refrigerant Coil Set Drain tray Filter Capillary Solenoid valve Filter dryer Solenoid coil On/Off switch Fan Motor Fan Blade Castor Rubber foot Compressor Mains Cable Front Grille Page 8 of 12 PART NUMBER 1619506 2018743 2018705 1019712 3014251 3020836 3020937 3030452 3035914 3947013 3947014 3050205 3101436 3944953 2141002 2018704 QUANTITY 1 1 1 1 1.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 WARNINGS This appliance can be used by children from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the application in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 Page 10 of 12
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 Page 11 of 12
Drawing : - TPC474 Issue :-2 Date : - 11/04/19 UK Head Office American Sales Office German Sales Office Ebac Industrial Products Ltd St Helens Trading Estate Bishop Auckland County Durham DL14 9AD Ebac Industrial Products Inc 700 Thimble Shoals Blvd. Suite 109, Newport News Virginia, 23606-2575 USA Ebac Industrial Products Ltd. Gartenfelder Str.
