FFG7755BK / FFG7751BN USE AND CARE GUIDE 52-INCH 4-BLADE INDOOR CEILING FAN Questions, problems, missing parts? Please Contact Customer Service 1-832-478-8866 WeCareWeFix@gmail.
Table of Contents Table of Contents.………...……………………… 2 Safety Information ………...………………………2 Warranty ……………………………………………3 Pre-installation …………………………………… 3 Specification …………………………………….3 Tools Required ………………………...………3 Hardware included ………………………...… 4 Package Contents ………………………….... 4 Wall Control Wiring Diagram …………………... 5 Remote Control Wiring Diagram ………………... 5 Assembly ……………………………………………. 6 Standard Ceiling Mounting ……….………………6 Hanging the Fan …………………………………. 7 Installing Remote Receiver…………….……….
Warranty The supplier warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a lifetime after the date of purchase by the original purchaser. The supplier also warrants that all other fan parts, excluding any glass or acrylic blades, to be free from defects in workmanship and material at the time of shipment from the factory for a period of one year after the date of purchase by the original purchaser.
Pre-Installation (continued) HARDWARE INCLUDED AA BB CC DD EE PACKAGE CONTENTS A Fan-Motor Assembly 1 pc B C Lamp cover 1 pc D LED light kit 1 pc E F Mounting bracket 1 pc H Canopy cover 1 pc J G Canopy 1 pc I Motor collar cover 1 pc K 4 pc Blades 4 Remote control 15cm Ball / downrod assembly 25cm Downrod 1 pc 1 pc 1 pc
Remote Control Wiring Diagram 5
Assembly – Standard Ceiling Mount ⚠ CAUTION: Be sure outlet box is grounded properly and that a ground wire (green or bare) is present. Partially loosen screws in slotted holes of the ceiling fan canopy. Remove the other 2 screws (along with the star washers) – save for later use. Twist canopy to remove the hanging bracket. Install hanging bracket to outlet box using original screws, spring washers and flat washers provided with new or original outlet box.
Assembly – Hanging the Fan Install downrod assembly □ □ □ □ Carefully feed the motor wires up though the downrod, thread the downrod into the collar. Align the holes and replace hanger pin and locking pin. Tighten the two collar setscrews. Slip coupling cover, canopy cover, and canopy onto the downrod Hang the fan □ Lift the fan motor assembly up to the mounting bracket and seat the hanger ball in the mounting bracket socket.
Installation – Blade and Light Kit □ □ □ Attach a blade to the fan motor housing by first inserting the blade into the slot in the side of the fan motor housing. Insert a screw into the bracket. Repeat for the two remaining screws. Tighten each screw securely. Repeat these steps for the remaining blades.
Fan Balance □ Put the clip in the center of a blade. Turn on the fan and if the shade persists, put the clip in another blade until the shade is reduced. Then this blade will need the counterweight □ Please the clip on the blade that needs the counterweight and try the best place to place it, from the center to the tip of the blade, until the wobble disappears □ Paste the counterweight on the surface of the blade which near the clip, remove the clip and test the fan.
Care and Cleaning ⚠ □ □ □ □ WARNING: Make sure the power is off before cleaning your fan Because of the fan’s natural movement, some connections may become loose. Check the support connections, brackets, and blade attachments twice a year. Make sure they are secure. It is not necessary to remove the fan from the ceiling. Clean your fan periodically to help maintain its new appearance over the years.
