Operation Manual

27
2. Configuration utility will scan for all wireless access points
automatically. Scan results will be displayed here, please check
if the wireless access point with the SSID (the name of wireless
access point) you preferred is shown here.
If the wireless access point you wish to connect does not show
here, please click ‘Rescan’ to try again, until the one you
preferred is displayed. You may have to click ‘Rescan’ for more
than two times before you can see the access point you wish to
use here sometimes.
If you still can not see the access point you wish to use after
clicking ‘Rescan’ for more than five times, please move your
computer closer to the location where the wireless access point
is, or see instructions in chapter 4-2 ‘Troubleshooting’.