Installation guide

13
Note: Please check the instructions for your wireless
router/access point to confirm how long you need to
hold down its WPS button to activate WPS for 2.4GHz
or 5GHz. Some brands of router/access point may not
support WPS for 5Ghz – in this case, please use iQ
Setup instead.
2. Within two minutes, press and hold the WPS
button on the extender for two seconds to
activate WPS. The WPS LED ( ) will flash
slowly to indicate WPS is activated (see LED
Status).
3. The devices will establish a connection. When a connection is
successful, the extender’s WPS LED ( ) will display on - and remain
on for 5 minutes (see LED Status).
4. Please wait for 5 minutes until the extender’s WPS LED ( ) is off, and
repeat this process to set up your dual-band extender’s additional
second frequency band. In step 1 please activate WPS on your
router/access point for the alternate frequency 2.4GHz or 5GHz
depending on which frequency you previously set up.
Press for two
seconds