User's Manual

2-2 Connect to Wireless Access Point
There are two ways you can configure your wireless network card to
connect to wireless access point: using the Ralink configuration utility
which comes with wireless card driver, and using built-in windows zero
configuration utility.
2-2-1 Using Ralink Utility
Please follow the following instructions to use Ralink configuration
utility to connect to wireless access point.
1. Right-click the Ralink configuration utility icon located at lower-right
corner of computer desktop, then click ‘Launch Config Utilities’.
2. Configuration utility will scan for all wireless access points
automatically. Scan results will be displayed here, please check if the
wireless access point with the SSID (the name of wireless access point)
you preferred is shown here.
If the wireless access point you wish to connect does not show here,
please click ‘Rescan’ to try again, until the one you preferred is
displayed. You may have to click ‘Rescan’ for more than two times
before you can see the access point you wish to use here sometimes.
If you still can not see the access point you wish to use after clicking
‘Rescan’ for more than five times, please move your computer closer
to the location where the wireless access point is, or see instructions in
chapter 3-2 ‘Troubleshooting’.