User's Manual

Authentication Mode: The wireless security

authentication mode of this access point will be

displayed here. If you don‟t enable security

function of the access point before WPS is

activated, the access point will auto set the security

to WPA (AES) and generate a set of passphrase key

for WPS connection.

Passphrase Key: Displays the WPA passphrase

here, all characters will be replaced by asterisk for

security reason. If encryption is not set on this

access point, nothing will be displayed here.

Config Mode

There are „Registrar‟ and „Enrollee‟ modes for the

WPS connection. When „Registrar‟ is enabled, the

wireless clients will follow the access point‟s

wireless settings for WPS connection. When

„Enrolle‟ mode is enabled, the access point will

follow the wireless settings of wireless client for

WPS connection.

Start PBC

Click „Start PBC‟ to start Push-Button style WPS

setup procedure. This access point will wait for

WPS requests from wireless clients for 2 minutes.

The „WLAN‟ LED on the access point will be

steady on for 2 minutes when this access point is

waiting for incoming WPS request.

Start PIN

Please input the PIN code of the wireless client

you via client wish to connect, and click „Start PIN‟

button. The „WLAN‟ LED on the access point will

be steady on when this access point is waiting for

incoming WPS request.

NOTE: When you’re using PBC type WPS setup, you must press

‘PBC’ button (hardware or software) of wireless client within 120

seconds; if you didn’t press PBC button of wireless client within

this time period, please press ‘PBC’ button (hardware or software)

of this access point again.