User's Manual

Wireless LAN Access Point Configuration

1d) Windows NT

1. Click the Start button and select Settings, then click Control Panel. The Control Panel

window will appear.

2. Double-click Network icon. The Network window will appear. Select the Protocol tab from

the Network window.

3. Check if the TCP/IP Protocol is on your list of Network Protocols. If TCP/IP is not installed,

click the Add button to install it now. If TCP/IP is installed, go to step 5.

4. In the Select Network Protocol window, select the TCP/IP Protocol and click the Ok

button to start installing the TCP/IP protocol. You may need your Windows CD to

complete the installation.

5. After you install TCP/IP, go back to the Network window. Select TCP/IP from the list of

Network Protocols and then click the Properties button.

6. Check each of the tabs and verify the following settings:

• IP Address: Select Specify an IP address. Specify the IP Address and Subnet Mask

as following example.

9 IP Address: 192.168.2.3 (any IP address within 192.168.2.2~192.168.2.254 is

available, do not setup 192.168.2.1)

9 Subnet Mask: 255.255.255.0

• DNS: Let all fields are blank.

• WINS: Let all fields are blank.

• Routing: Let all fields are blank.

7. Click OK to confirm the setting. Your PC will now have the IP Address you specified.

2. Enter 192.168.2.1 from Web Browser to get into the Access Point’s

configuration tool.