User's Manual

51
if the camera is active.
IV-5-2. Advanced
The “Advanced” page allows you to upgrade the network camera’s firmware,
backup or restore the network camera’s settings, and reset or restart the
network camera.
Do not switch off or disconnect the device during a firmware
upgrade, as this could damage the device.
Firmware Filename
Click “Browse” to locate the firmware file on
your computer.
Upgrade Firmware
Click to upgrade the firmware to your
selected file.
Backup Settings
Click “Apply” to save the current settings on
your computer as config.bin file.
Restore Settings
Click “Browse” to find a previously saved
config.bin file and then click “Upload” to
replace your current settings.
Restart
Click “Restart Network Camera” to restart the
network camera. Please wait a couple of
minutes for network camera to boot up after