User Manual

ManualsBrandsEdgeStar ManualsAppliancesDouble Tap 24 in. Full Size Beer Keg Dispenser with Digital Display in Black

SAFETY PRECAUTIONS

Read all of the instructions before using this appliance. When using

this appliance, always exercise basic safely precautions, including the

following:

 This appliance is designed for household use only and not for commercial

use. Do not use the appliance for uses other than that for which it is

designed.

 Do not use the appliance if the power supply cord is damaged. If the

power supply cord is damaged, it must be replaced by a qualified

technician.

 This unit is designed to function on 115 Volts/ 60 Hz (110/115/120 Volts

acceptable) electrical circuits.

 This appliance is not designed for children. Never allow unattended

children to use this appliance.

 Unplug the appliance if it will not be used for an extended period of time.

 Unplug the appliance prior to cleaning.

 Set the appliance on a level surface away from direct sunlight and other

heat sources.

 This appliance is designed to function optimally in room temperature

environments (mid 70°s Fahrenheit).

 Do not move the unit while it is full.

 The power supply cord must be grounded.

 Never pull the power supply cord directly to disconnect the appliance.

Always pull the plug out of the socket.

 Never lift the appliance by the power supply cord or the dispensing tap.

 Keep the power supply cord away from heating surfaces.

 Service only by authorized technicians.

 Do not immerse the appliance or its power supply cord in water or any

other liquid.

 Do not cover the appliance or place anything on it.

 Do not insert any objects into the ventilation holes.

 Only use approved CO

cylinders. Make sure you read and understand all

the procedures for the CO

cylinders before installation.

 Cylinders contain pressurized CO

. Keep them away from heat, and store

in a dry and cool place. CO

cylinders should always be connected to a

regulator! Failure to do so may cause an explosion resulting in possible

death or injury when the cylinder valve is opened.

 Do not dispose of empty CO

cylinders in a fire. Never drop or throw a CO

cylinder.

 Clean this appliance regularly, and after every keg.

 If you are replacing an older appliance with this unit, take care to remove

the door of the old appliance before throwing it away. This will alleviate the

risk of child entrapment.

Summary of content (16 pages)

PAGE 1
SAFETY PRECAUTIONS Read all of the instructions before using this appliance. When using this appliance, always exercise basic safely precautions, including the following:                       This appliance is designed for household use only and not for commercial use. Do not use the appliance for uses other than that for which it is designed. Do not use the appliance if the power supply cord is damaged.
PAGE 2
Welcome and Thank You Welcome and thank you for purchasing this EdgeStar Draft Beer Dispenser. We are glad you choose us and we take pride in knowing that like our products our customer service will be just as dependable. Once you complete our easy unit set up by following the manual, it will provide you years of great service. We ask all of our customers to please save the original product packaging in case you need to safely transport this portable Draft Beer Dispenser in the future.
PAGE 3
TABLE OF CONTENTS ________________________________________________________________________ UNPACKING ACCESSORIES AND INVENTORY.................... 4 Additional Accessories.................................................. 4 Proper Location........................................................ 4 ASSEMBLY INSTRUCTIONS..................................... 5-7 Installing the Casters................................................... Installing the Beer Tap.................................................
PAGE 4
UNPACKING ACCESSORIES AND INVENTORY Your Draft Beer Dispenser is supplied with all the accessories you need to install and tap a standard American Sankey Tap ½ barrel keg. This unit can also fit ¼ barrel, 1/6 barrel, and Cornelius kegs with standard American Sankey Tap connections. All you need to do is set up the Draft Beer Dispenser, supply the full keg of beer, and fill the CO tank.
PAGE 5
ASSEMBLY INSTRUCTIONS Installing the Casters 1. With the contents inside the cabinet removed set the beer dispenser on its side. 2. Insert each caster into the holes on the bottom corners of the cabinet. Screw the casters in hand tight. 3. With all four casters tightened evenly, stand the unit in an upright position. Note: Allow the refrigerator to stand in an upright position for 8 hours before turning on the power. This will ensure that the coolant has settled. Installing the Beer Tower and Faucet 1.
PAGE 6
Connecting the CO2 Cylinder to the CO2 Regulator and Installing the CO2 Cylinder Holder Warning CO2 can be dangerous! CO2 cylinders contain high-pressured gas, which can be hazardous if handled improperly. Please handle with care. Note This section describes general CO2 and keg installation. For specific instructions, see the instructions included in the accessory box. 1. To install the CO2 gas line tube to the regulator, attach one end of the CO2 tube, to the hose barb connection on the CO2 regulator.
PAGE 7
Your beer dispenser comes with American Sankey Tap. Before purchasing a keg, check with your beer distributor to make sure that supplied American Sankey Tap can be used. Many European beers require a different tap. Please contact EdgeStar customer service online via email at service@edgestar.com or by telephone at 1-866-319-5473 for more information. 1.
PAGE 8
OPERATING YOUR FRIDGE & BEER DISPENSER Grounding Instructions     This appliance’s plug must be grounded. In the event of a malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electrical current. Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under any circumstances, cut or remove the third (ground) prong from the power cord.
PAGE 9
Setting the Regulator EdgeStar’s Draft Beer Dispenser comes with a single gauge CO2 gas regulator that has a 0-60 lb. pressure gauge showing the gas output pressure. Once the regulator is securely attached to the gas cylinder: 1. Close the shut-off valve on the regulator, and open the valve on the cylinder completely. 2. Slowly turn the regulator adjustment screw until the desired pressure is shown on the output gauge.
PAGE 10
Dispensing the Beer and Proper Drawing Technique Note: Allow the keg to settle and acclimate to refrigeration for 2-4 hours prior to dispensing beer. Using the proper draw technique to dispense beer should allow you to fill a 12 oz glass leaving approximat ely ¾”-1” of foam. 1. Make sure that the beer dispenser is plugged in properly to a 120V, 60Hz, 15Amp grounded outlet. 2. Rinse a “Beer Clean” glass under cold water. (see below for more information on “Beer Clean”) 3.
PAGE 11
Understanding Beer Temperature  Select and maintain the proper temperature inside the refrigerator cabinet. This is necessary to maintain the flavor freshness of the beer. Adding additional unrefrigerated products, such as meats, vegetables, fish, etc. while attempting to chill beer will cause a fluctuation in the temperature, resulting in cloudy beer.  The recommended temperature for storing and serving chilled beer is between the high 30s and mid 40s.
PAGE 12
Understanding the Temperature Control Setting This kegerator has a cooling range of 32-50 °F (0-10 °C). Press the cooler or warmer buttons to adjust temperature by 1°. Press the F/C button to switch between Fahrenheit or Celsius. Press Deep Chill to activate the quick cooling feature of this kegerator. Press the button again to exit Deep Chill mode. Deep Chill should be used to quickly cool a new warm kegerator. The machine will operate continuously for 24 hours and exit this mode after 24 hours.
PAGE 13
Beer Serving Guide What a half barrel (full keg) of beer provides you: No. Glasses 192 236 264 290 353 4 Glass Size 12 oz. 10 oz. 9 oz. Half Barrel (full size) Keg = 15.5 Gallons 8 oz. = 1984 Fluid Ounces 7 oz. Half Barrel (full size) Keg = 6.75 Cases of 12 ounce Bottles 6 oz. CONVERTING THE BEER DISPENSER TO A REFRIGERATOR This dispenser can be converted to an all refrigerator appliance. 1. Safely disconnect the CO2, keg, and all lines.
PAGE 14
TROUBLESHOOTING THE BEER DISPENSER Problem Excess formation of foam “head.” Beer, when drawn is all foam, or too much foam and not enough liquid beer. Possible Causes Recent keg agitation Improper regulator setting Internal temperature of the keg cabinet is too warm. Pressure build up Flat Draft, no formation of foam. Foamy head disappears quickly; beer lacks usual zestful brewery fresh flavor Improper draw technique Improper regulator setting.
PAGE 15
Sputtering Draw Dispense system requires cleaning. Keg Coupler installed incorrectly Line or dispenser obstructions. Improper draw technique Faucet Dripping Handle not fully returned to close position. Faucet requires cleaning Rapid CO2 cylinder discharge Improper connection, air line leak Difficulty Manipulating Faucet handle Faucet requires cleaning Damaged handle stem Abnormal beer taste and/or smell Dispense system requires cleaning. Contaminated dispense system. The beer exceeded self-life.
PAGE 16
LIMITED WARANTY This EdgeStar product is warranted to be free from defective workmanship and materials for the first year following the date of original purchase. Replacement parts will be supplied free of charge for the first year following the date of original purchase. Labor will be performed free of charge for the first 90 days following the date of original purchase.