Combo Washer/Dryer CWD1510W Owner's Manual For more information on other great EdgeStar products on the web, go to http://www.edgestar.
IMPORTANT SAFETY IN FORMATION Improper handling can cause serious damage to the EdgeStar combo and/or injury to the user. This combo washer/dryer is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the ratings label located on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used in a properly grounded wall outlet.
General Safety • • • • • • • • • • • • • • • • • • EdgeStar Washer/Dryer Combo Do not wash articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry-cleaning solvents, or other flammable or explosive substances, as they give off vapors that could ignite or explode. Do not add gasoline, dry-cleaning solvents, or other flammable or explosive substances to the wash wafer. These substances give off vapors that could ignite or explode.
• • • • • • • • • • Disconnect power and water supply after operation. Pull out its plug and cut off water supply after the operation. Please check whether the water inside the drum has been drained before opening its door. Please do not open the door if there is any water visible. Do not try to repair any internal components by yourself, contact a qualified service technician for non-user repair issues.
Table of Contents IMPORTANT SAFETY INFORMATION ..................................................................... I INTRODUCTION ................................................................................................... 1 PARTSIDENTIFICATION ....................................................................................... 2 BACK ViEW ............................................................................................................. 2 3 DETERGENT DISPENSER ................
INTRODUCTION Thank you for purchasing this EdgeStar combo washer/dryer. We are glad you chose us. We believe that your purchase of this product opens a relationship between you and EdgeStar. We will provide the customer support needed to nurture that relationship. This manual contains important information regarding the proper installation, use and maintenance of your combo. Following this manual will ensure that your product will work at its peak performance and efficiency.
PARTS IDENTIFICATION Front View I O Detergent Dispensing Drawer- There is three compartments and fabric softener. for prewash, Glass Door- Extra-large door with lock. Door automatically prevent door opening before wafer level has lowered. locks during operation Leveling Feet- The unit comes with four adjustable leveling floors. Combo Washer should always be level fo efficiently main wash, to feet for spaces with uneven operate.
Back View Electrical Plug- This unit is supplied with a three prong plug. requirements before connecting the unit. Please check electrical Drain Hose- The drain hose directs the flow of wafer after the wash cycle. The drain hose should always be properly secured fo avoid risk of flooding and/or property damage. Water Inlet Valve- There are two wafer inter valves: The left side is hot and the right side is cold. Connect the two hoses bundled with the unit fo the tap connection.
Detergent Dispenser Your washing machine is designed for use with only High-Efficiency (HE) detergents. They are formulated specifically for front-load washers and contain suds-reducing agents. Using a regular detergent that is not High-Efficiency sudsing and may affect the unit's performance. may cause over- Designed specially to use only HE(High-Efficiency)detergent ® Release Tab- To remove the dispenser drawer from unit, push down on the release tab and pull drawer out.
PREPARATION Electrical FOR INSTALLATION Requirements Failure to follow electrical requirements can cause personal injury, fire, or electrical shock. Install the combo washer/dryer according to the manufacturer's instructions and local codes. To reduce the risk of severe injury or death, follow all installation even after installation is complete. • Note: When you plan to dispose of this machine in the future, please comply with the local waste disposal regulations.
Installation • • • • • The dimensions clearances The Iocafion musf be large enough fo atlow fhe washer door fo be fully opened. Addifionat spacing should be considered for ease of insfallafion and servicing. The door opens more fhan 90°, and if is nor reversible. Addifionat clearances mighf be required for woN, door, and floor moldings. Addifionat spacing of ] inch on atl sides of fhe washer is recommended fo reduce noise fransfer Make sure fhe combo is insfatled fo access fhe elecfricat ouflef.
Tools and Parts Water Hoses (2) Gather the required tools Transportation "Shipping" installation. • • • • • • • • • Transportation "Shippinq" Pluqs ©© © The accessories are located in the washer the washing drum. in drum machine Unpack your washer/dryer combo and inspect for damage that may have occurred during transportation. If there is any damage fo the washing machine or any item is missing, please contact your dealer immediately.
INSTALLATION Connect inlet pipe Connect the inlet pipe as indicated in the figure below. Connect the hot inlet valve fo the hot wafer tap and cold inlet valve fo the cold wafer tap. ............... ,i' i!!;4 _i_ _ Install inlet pipe Connect the elbow fo the inlet valve af the backside of washing machine and fasten if fuming clockwise. Connect the other end of inlet pipe fo the tap and fasten the pipe tightly clockwise.
Drain System Options: Standpipe drain system - wall or floor (views A & B) - The standpipe drain requires a minimum diameter standpipe of 2" (50 mm). The minimum carry-away capacity can be no less than ] 7 gal. (64 L) per minute. The fop of the standpipe must be af least 24" high and no higher than 39" from the bottom of the washer. Laundry tub drain system (view C) - The laundry tub needs a minimum 20 gal. (76 L) capacity. The fop of the laundry tub must be af least 24" above the floor.
Level the washer When positioning the washer/dryer combo, please first check if the legs are closely attached fo the cabinet. If not, please turn them fo their original positions by hand or with wrench and tighten the nuts with wrench. After positioning the washing machine, apply pressure on each corner of the combo in sequence. If the unit is unstable when being pressed, the legs must be adjusted fo level the machine. , ii ............ Ensure the positioning status of the machine.
Electrical • • • • • • • • 11 Connection As the maximum current through the unit is 12A when you are using its heating function, please make sure the power supply system (current, power voltage and wire) at your home can meet the normal loading requirements of the electrical appliances. Please connect the power fo a socket which is correctly installed and properly grounded. Make sure the power supply voltage is compatible with the machine's rating label.
OPERATING INSTRUCTIONS Please read the operation service calls and damages Control Panel Overview Control Knob instructions carefully to clothes. Co_on/NormaI to avoid unnecessary Speed Wash Se|f C_ean Power Delicate Hand Wash /Wool Dry BabyWear Start/ Pause @ Hold 3 Sec Add Garment Power- Press to start the display panel. the washer into standby mode. If the display is active, press to put Start/Pause- Press to start desired wash cycle.
Hand Wash/Wool: Select this option fo wash the wool textiles labeled with "Machine Wash" only. If is suggested fo wash only small loads and with wool-safe detergent. In this cycle the fumble action will agitate less and will be af a lower spin speed. Baby Wear- Select this option for baby clothes and people with skin allergies. The wash cycle will automatically have an extra rinse. Self-Clean- Run the self-clean regularly fo remove detergent buildup and other residue from the machine itself.
LED Display @ I I Add DryTime I [ ® Soil Level Indicator-indicates Cycle Indicator- soil level chosen (See Button 10) Indicates at what stage of the wash/dry cycle machine is in: _'_ewas,was,_,nse s0,n _'o_ Wash/Cycle Lifecycle Indicator- Reflects time left until end of cycle © Feature Indicator- Indicates features that are active: - Machine is locked for duration of cycle. __- Child Lock is on for control panel.
Spin Speed- Press to increase 1200RPM. This reduces drying spin speed time, the washer drum spins at a speed up to time and saves energy. Press the button until desired speed is lit, speed increases in increments delicates require a slower spin speed. of 200, 400-1200 rpm. Some fabrics such as Soil Level- Press fo increase time for heavier soiled items. There are three soil levels, each bar increases the base wash time by five minutes. Child Lock- Press the soil level and delay control panel.
Tips before Washing Check for colorfastness. Before washing any new garment you should always check to see if the color will bleed to avoid damaging other items in the same wash cycle. Checking for colorfastness is easy. Simply wet one corner of the fabric and let it set for a few minutes. Get a white cloth and press down on the wet part of the garment/item. If any color comes off onto the white cloth, you know the item is not colorfast and will run in the wash cycle.
• f • NOTE: It is normal if you clothes feel slightly fasfeners, zips should be zipped close and buffons or hooks should be fasfened. Any loose ribbons or lies should be fled fogefher. Clofhes should always be washed/separated according fo fhe following characferisficsfabric Type, color, size, and sensifivify. Always wash according fo label insfrucfions. Clofhes wifh butfons, embroideries, or fraying inside out before being washed. Remove all pins/hooks from arficle of clofhing washed.
Washing/Drying Capacity: Do nor overload fhe unif; otherwise if may diminish fhe washing effecfs. Please confirm fhe maximum affordable washing quantify according fo fhe following fable. Cotton t 5 Ibs 7 ]/2 Ibs Artifica[ Fibers 8 [bs 4 ibs Woot 5 1/2 ibs 2 3/4 ibs DO NOT WASH ANY SINGLE LARGE ITEM AS IT WILL DAMAGE Incorrecf Correcf EdgeStar Washer/Dryer Combo UNIT.
OPERATING THE WASHER Before washing clothes for the first time, the washing machine should be run through a full cycle with detergent without articles of clothing. Once you have loaded now ready to wash! Start up washing © the washer and added laundry products, you are machine Make sure the unit is connected to power and ensure water lines are connected properly; the tap should be opened completely. Place your already sorted wash load into the drum. Press the "Power" button.
Cycle Guide CYCLE GUIDE This guide _l_w_ you _he o_tkms and prese_ optl@ns f_r _'@_@mmended J Falbric types fgr ead_ yde j @ i__jae_;f_c_yde / I 1 O0 _F 90 F i_Jp (::old / | o#_on {s tvtilable 1O0 _F and at) t@| / DDfWa_l'lit@/_ I rl/t:)_af<_d | Spin Speed 'ihe i_r_S_ / f_mP/pfts _f:Jeedis bo!d_d | W I_00 i 600 40{i Delk_te Hamd W_'_sh/ VV_ol 9'0 _f 600 Tap ¢ott 4_0 NO Spin tap Cold @_ N_ gpi_ i (_ F Babywt÷_r _0 °F l'ip Cold 1200 _OtX:_ 80
CARE AND MAINTENANCE Periodic cleaning and proper maintenance will ensure efficiency, performance, and long life and is recommended. Disconnect plug from outlet and close wafer tap before cleaning/maintenance fo your combo washer/dryer. Cleaning the exterior performing fop any of the unit Never use solvent based, abrasive cleaners, harsh chemicals or steel wool fo clean your unit as they can damage the finish.
Clean inlet filter If tap is fully opened and there is an insufficient amount of water coming through the hose you may need fo clean your Inlet filter. Wall Connection 1. 2. Close the tap entirely before cleaning. Select any procedure on control knob and press the "Start/Pause" button and let run for about 40 seconds. 3. 4. Remove the inlet pipe from tap which is connected Run warm wafer fo run through filter and reconnect hose. on the wall. inlet pipe fo Unit Connection 1.
TROUBLESHOOTING Before Calling TIPS for Service If the unit appears to be malfunctioning, following the suggestions in the "Solution" Possible Issue Washing Mqchine no_ start POOl CannOt be openea Wa_er leakage Waler is leaking flora me botlom machine o! the or Can NOHT'_Q_/V wash the clothes orw cannot wash with nearing. Contact authorized teclY'_id_sn Tl;_econr, echons are not fiqht Drair o_oe is BlOCked.
TROUBLESHOOTING TIPS CONTINUED... Sobtton Door lock Doo_ problem s nor ch:)sed Piease call on ouihodzed T_p is no_ opened Wa_e_ inferject_ng issue when w®y Iniel ;w®sh]n9 bv®'ler in:te!'ieciin9 _ha{ exceeds 5 rains} wa_et volve Please Ca!ion Care authorized techn ,a_i the ca_ian autho_zed eehn_c4on e ed o_ter _he doo_ c an f Open flows fOos!Ow_y fiiie_ s becked inie_ pip:e may be iwis w®iel s no_ st_pptied Peose Resfa_ property.
SPECIFICATIONS Description of product Combo Washer/Dryer Model CWD1510W Voltage/Frequency AC 115V-60Hz Rated 12A Current Color White Washing cabinet with chrome door 15 Ibs. / 7.7 Ibs. Capacity/ Dry Capacity Drum Size Standard 2.0 cu. ft. Water Pressure Weight Note: Technical data reference only. 0.05MPa-1MPa 165 Ibs. and performance information Specifications are subject to change. Check maker for the most accurate information.
This product is warranted by EdgeSfar and is subject fo any conditions WHAT IS COVERED: WHAT IS NOT COVEREDcoverage For a period of ONE (1) YEAR from the date of original retail purchase, EdgeSfar will repair or replace any part free of charge including that fails due fo a defect in materials or labor workmanship. Labor will be performed free of charge at an authorized EdgeStar repair facility and EdgeStar will supply new, rebuilt, or refurbished parts free of charge.
Reassembly of the coin trap/lint trap component of the EdgeStar Washer Dryers If the end piece of the coin trap component on EdgeStar combination washer dryers is fully unscrewed, the component can come completely apart. Here is how you re-assemble it t. Start with the pieces 2. Put the rubber gasket onto the end of the Ion . shown in the order below. _iece, as show below. as shown below. Put the white piece 4, Lightly screw the remaining 5. Now the component into the combo.
Note: here is another view of the correct order and _lacement of the component parts:
To use, simply and water hook inlet hoses.
ISimplv replace the leveling legs on the unit with these locking casters I
@ EdgeStar Products 500 N. Capital of TX Hwy, Bldg 5 Austin, TX 78746 Toll Free: 1-866-319-5473 Web: http://www.edgestar.com E-mail: service@edgestar.com Register your product, download owner's manuals, access additional troubleshooting resources, and obtain more information on other great EdgeStar products on the web at: http://www.edgestar.com Product contents Copyright and specifications © 2011 Living may change without notice. Direct, Inc. All rights reserved.
