ECS4110-28P_Management Guide

C HAPTER 27 | Interface Commands
Interface Configuration
– 996 –
Interface Configuration
interface This command configures an interface type and enters interface
configuration mode. Use the no form with a trunk to remove an inactive
interface.
SYNTAX
[no] interface interface-list
interface-list – One or more ports. Use a hyphen to indicate a
consecutive list of ports or a comma between non-consecutive ports.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
vlan vlan-id (Range: 1-4094)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
transceiver-threshold
temperature
Sets thresholds for the transceiver temperature which
can be used to trigger an alarm or warning message
IC
transceiver-threshold
tx-power
Sets thresholds for the transceiver power level of the
transmitted signal which can be used to trigger an
alarm or warning message
IC
transceiver-threshold
voltage
Sets thresholds for the transceiver voltage which can
be used to trigger an alarm or warning message
IC
show interfaces
transceiver
Displays the temperature, voltage, bias current,
transmit power, and receive power
PE
show interfaces
transceiver-threshold
Displays the alarm/warning thresholds for
temperature, voltage, bias current, transmit power,
and receive power
PE
Cable Diagnostics
test cable-diagnostics Performs cable diagnostics on the specified port PE
show cable-diagnostics Shows the results of a cable diagnostics test PE
Power Savings
power-save Enables power savings mode on the specified port IC
show power-save Shows the configuration settings for power savings PE
Table 113: Interface Commands (Continued)
Command Function Mode