ECS4110-28P_Management Guide

C HAPTER 24 | Authentication Commands
Web Server
– 847 –
Interface : Eth 1/1
Method List : tps
Group List : radius
Interface : Eth 1/2
Accounting Type: EXEC
Method List : default
Group List : tacacs+
Interface : vty
Console#
WEB SERVER
This section describes commands used to configure web browser
management access to the switch.
N OTE : Users are automatically logged off of the HTTP server or HTTPS
server if no input is detected for 300 seconds.
ip http port This command specifies the TCP port number used by the web browser
interface. Use the no form to use the default port.
SYNTAX
ip http port port-number
no ip http port
port-number - The TCP port to be used by the browser interface.
(Range: 1-65535)
DEFAULT SETTING
80
COMMAND MODE
Global Configuration
Table 82: Web Server Commands
Command Function Mode
ip http port Specifies the port to be used by the web browser
interface
GC
ip http server Allows the switch to be monitored or configured from
a browser
GC
ip http secure-port Specifies the UDP port number for HTTPS GC
ip http secure-server Enables HTTPS (HTTP/SSL) for encrypted
communications
GC