ECS4110-28P_Management Guide

C HAPTER 19 | Using the Command Line Interface
Entering Commands
– 704 –
◆ Class Map Configuration - Creates a DiffServ class map for a specified
traffic type.
◆ ERPS Configuration – These commands configure Ethernet Ring
Protection Switching for increased availability of Ethernet rings
commonly used in service provider networks.
◆ IGMP Profile - Sets a profile group and enters IGMP filter profile
configuration mode.
◆ Interface Configuration - These commands modify the port
configuration such as speed-duplex and negotiation.
◆ Line Configuration - These commands modify the console port and
Telnet configuration, and include command such as parity and
databits.
◆ Multiple Spanning Tree Configuration - These commands configure
settings for the selected multiple spanning tree instance.
◆ Policy Map Configuration - Creates a DiffServ policy map for multiple
interfaces.
◆ Time Range - Sets a time range for use by other functions, such as
Access Control Lists.
◆ VLAN Configuration - Includes the command to create VLAN groups.
To enter the Global Configuration mode, enter the command configure in
Privileged Exec mode. The system prompt will change to
“Console(config)#” which gives you access privilege to all Global
Configuration commands.
Console#configure
Console(config)#
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
Table 48: Configuration Command Modes
Mode Command Prompt Page
Line line {console | vty} Console(config-line) 749
Access
Control List
access-list ip standard
access-list ip extended
access-list ipv6 standard
access-list ipv6 extended
access-list mac
Console(config-std-acl)
Console(config-ext-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
Console(config-mac-acl)
970
970
978
979
983
CFM ethernet cfm domain Console(config-ether-cfm) 1347
Class Map class-map Console(config-cmap) 1208
ERPS erps domain Console(config-erps) 1119