ECS4110-28P_Management Guide

C HAPTER 17 | IP Services
Configuring the PPPoE Intermediate Agent
– 676 –
Figure 406: Configuring Interface Settings for PPPoE Intermediate Agent
g
SHOWING PPPOE IA
STATISTICS
Use the IP Service > PPPoE Intermediate Agent (Show Statistics) page to
show statistics on PPPoE IA protocol messages.
CLI REFERENCES
◆ "show pppoe intermediate-agent statistics" on page 886
◆ "clear pppoe intermediate-agent statistics" on page 885
PARAMETERS
These parameters are displayed:
◆ Interface – Port or trunk selection.
◆ Received – Received PPPoE active discovery messages.
■
All – All PPPoE active discovery message types.
■
PADI – PPPoE Active Discovery Initiation messages.
■
PADO – PPPoE Active Discovery Offer messages.
■
PADR – PPPoE Active Discovery Request messages.
■
PADS – PPPoE Active Discovery Session-Confirmation messages.
■
PADT – PPPoE Active Discovery Terminate messages.
◆ Dropped – Dropped PPPoE active discovery messages.
■
Response from untrusted – Response from an interface which
not been configured as trusted.
■
Request towards untrusted – Request sent to an interface which
not been configured as trusted.
■
Malformed – Corrupted PPPoE message.