ECS4110-28P_Management Guide

C HAPTER 15 | Multicast Filtering
Multicast VLAN Registration for IPv4
– 616 –
Figure 363: Showing the Static MVR Groups Assigned to a Port
DISPLAYING MVR
RECEIVER GROUPS
Use the Multicast > MVR (Show Member) page to show the multicast
groups either statically or dynamically assigned to the MVR receiver groups
on each interface.
CLI REFERENCES
◆ "show mvr" on page 1293
PARAMETERS
These parameters are displayed:
◆ Domain ID – An independent multicast domain. (Range: 1-5)
◆ Group IP Address – Multicast groups assigned to the MVR VLAN.
◆ VLAN – Indicates the MVR VLAN receiving the multicast service. Note
that this may be different from the MVR VLAN if the group address has
been statically assigned.
◆ Port – Shows the interfaces with subscribers for multicast services
provided through the MVR VLAN.
◆ Up Time – Time this service has been forwarded to attached clients.
◆ Expire – Time before this entry expires if no membership report is
received from currently active or new clients.
◆ Count – The number of multicast services currently being forwarded
from the MVR VLAN.
WEB INTERFACE
To display the interfaces assigned to the MVR receiver groups:
1. Click Multicast, MVR.
2. Select Show Member from the Step list.
3. Select an MVR domain.