ECS4110-28P_Management Guide

C HAPTER 43 | OAM Commands
– 1393 –
(page 1392) is reached or exceeded within the period specified by this
command. The Errored Frame Event TLV includes the number of errored
frames detected during the specified period.
EXAMPLE
This example set the window size to 5 seconds.
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam link-monitor frame window 50
Console(config-if)#
efm oam mode This command sets the OAM mode on the specified port. Use the no form
to restore the default setting.
SYNTAX
efm oam mode {active | passive}
no efm oam mode
active - All OAM functions are enabled.
passive - All OAM functions are enabled, except for OAM discovery,
and sending loopback control OAMPDUs.
DEFAULT SETTING
Active
COMMAND MODE
Interface Configuration
COMMAND USAGE
When set to active mode, the selected interface will initiate the OAM
discovery process. When in passive mode, it can only respond to discovery
messages.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam mode active
Console(config-if)#