ECS4110-28P_Management Guide

C HAPTER 41 | LLDP Commands
– 1337 –
DEFAULT SETTING
Not advertised
No description
COMMAND MODE
Interface Configuration (Ethernet, Port Channel)
COMMAND USAGE
◆ Use this command without any keywords to advertise location
identification details.
◆ Use the ca-type to advertise the physical location of the device, that is
the city, street number, building and room information. The address
location is specified as a type and value pair, with the civic address (CA)
type being defined in RFC 4776. The following table describes some of
the CA type numbers and provides examples.
Any number of CA type and value pairs can be specified for the civic
address location, as long as the total does not exceed 250 characters.
◆ For the location options defined for device-type, normally option 2 is
used to specify the location of the client device. In situations where the
client device location is not known, 0 and 1 can be used, providing the
client device is physically close to the DHCP server or network element.
Table 190: LLDP MED Location CA Types
CA Type Description CA Value Example
1 National subdivisions (state, canton, province) California
2County, parish Orange
3City, township Irvine
4 City division, borough, city district West Irvine
5 Neighborhood, block Riverside
6 Group of streets below the neighborhood level Exchange
18 Street suffix or type Avenue
19 House number 320
20 House number suffix A
21 Landmark or vanity address Tech Center
26 Unit (apartment, suite) Apt 519
27 Floor 5
28 Room 509B