998.5-2002 Dodge Cummins 5.
© 2007 Edge Products All rights reserved. Edge Products 1080 South Depot Dr. Ogden, UT 84404 1-888-360-3343 www.edgeproducts.
TABLE OF CONTENTS DISCLAIMER OF LIABILITY _________________________________________________ 4 LIMITATION OF WARRANTY _________________________________________________ 4 Installation Instructions _______________________________________________________ 7 Items Required: ___________________________________________________________________7 Supplied Items: ____________________________________________________________________7 Module Installation ________________________________________________________________7 Da
THIS IS A HIGH PERFORMANCE PRODUCT. USE AT YOUR OWN RISK. Do not use this product until you have carefully read the following agreement. This sets forth the terms and conditions for the use of this product. The installation of this product indicates that the BUYER has read and understands this agreement and accepts its terms and conditions DISCLAIMER OF LIABILITY Edge Products Inc.
This warranty is void for any new products purchased through auction websites. Warranty is valid only for new products purchased through Authorized Dealers (proof of purchase required for all warranty claims). All Edge modules and programmers are built to operate with OEM calibrations. When you take your vehicle to a service center they may, by your request or otherwise, update your vehicles calibrations. Therefore it is important that you return your vehicle to stock before taking it in for service.
Thank you for purchasing the Edge Module for the 24 Dodge Valve Cummins®. The Edge has been developed and produced of the highest quality to ensure the best performance for years to come. If you have any concerns or questions please contact us. The Edge Module is a high performance product It is strongly recommended that EGT gauges and boost gauges be installed with the use of this product.
Installation Instructions IMPORTANT: Read all Disclaimer, Warranty, and Installation Instructions before installing product Items Required: Pliers Flat tip Screwdriver 1/2” Wrench 3/8” Drive Ratchet & Sockets 1/4” Socket 5/16” Socket 7/16“ Deep Well Socket Supplied Items: 1. 2. 3. 4. 5. Edge EZ Module Three Wire Ties Two Velcro Strips One Hose Clamp One 90° Brass Fitting Module Installation 1. The Edge EZ Module can mount on the flat black plastic fuse box cover located on the driver’s side fender.
Data Link Connection 2. The Data Link connector is located in different locations based on the year of the truck: • 98.
Boost Elbow Installation (Optional) The installation of the brass elbow permits turbo boost pressures of greater than 20 psi without the wastegate opening. The Edge EZ Module will operate equally well with or without this installed. 5. Using the 5/16” socket, loosen the two clamps securing the air induction hose to the air filter housing and the turbo inlet. Remove the hose and set it aside. 6.
Power Gains The following power gains are representative of an actual test vehicle. Power gains may vary somewhat on a different vehicle or in different geographic settings. Level 1: Level 1: Level 3: Horsepower Torque 60 160 63 170 65 180 Technical Support 888-360-3343 To expedite your support call, please have part number (i.e., EZD1000), version number, and Date of Manufacture ready prior to calling support.
