Measurement Guide

You will need the following tools:
Pencil - Drill - Screwdriver - Step Ladder
Installation Instructions
WRAP ROD
For helpful videos & more
information visit
eclipsecurtains.com
or scan this QR code
with your smartphone
Wood walls
Other walls
1. Loosen the screws on the end of both
pole sections to release the end plates.
2. Identify the larger and smaller end plates.
Note on which side of the window each one
will be mounted as they will have to match
their respective pole ends.
2.8cm end
2.5cm end
1cm
2cm
3. Position each end plate and use it as a guide
to mark the screw positions.
If using a centre bracket, mark the top screw
position 1cm over the horizontal line and the
bottom screw 2cm under the line.
4. Drill the holes and secure the end plates with the
appropriate fixings. If you are unsure, consult
your local DIY store.
5. Slide each curtain on each half of the extendable
pole. Slide the smallerr pole inside the larger one.
7. Place thee pole in position onto the end plates
making sure that the larger ad smaller ends of the
poles are facing their respective and plates.
If using a center bracket, ensure that the cup is
supportinng the pole (adjust thhe bracket if
necessaary).
8. Secure the pole on the end plates by tightening
the short grub screw underneath the pole.
If using the center bracket, tighten the grub screw
at the back of the cup.
6. Place the larger and smaller cover plates onto
their respective and plates.