MSDS

Echo Power Blend Two-Cycle Engine Oil
Notes to Physician
INGESTION: The viscosity range of the product(s) represented by this MSDS is greater than
100 SUS at 100°F. Careful gastric lavage may be considered to evacuate large quantities of
material.
NFPA Flammability
Classification
Autoignition
Temperature
Hazardous Combustion
Products
Flash Point
Extinguishing Media
Lower Flammable Limit
Protection of Fire
Fighters
Not available.
NFPA Class-IIIA combustible liquid.
Carbon dioxide, carbon monoxide, smoke, fumes, unburned hydrocarbons and oxides of
sulfur and/or nitrogen.
Closed cup: 68°C (154°F). (Pensky-Martens (ASTM D-93)) Open cup: 84°C (183°F)
(Cleveland.).
No data.
SMALL FIRE: Use dry chemicals, carbon dioxide, foam, or inert gas (nitrogen). Carbon
dioxide and inert gas can displace oxygen. Use caution when applying carbon dioxide or
inert gas in confined spaces.
LARGE FIRE: Use foam, water fog, or water spray. Water fog and spray are effective in
cooling containers and adjacent structures. However, water can cause frothing and/or may
not extinguish the fire. Water can be used to cool the external walls of vessels to prevent
excessive pressure, autoignition or explosion. DO NOT use a solid stream of water directly
on the fire as the water may spread the fire to a larger area.
Firefighters must use full bunker gear including NIOSH-approved positive pressure
self-contained breathing apparatus to protect against potential hazardous combustion or
decomposition products and oxygen deficiencies. Withdraw immediately from the area if
there is a rising sound from a venting safety device or discoloration of vessels, tanks, or
pipelines.
This material will release vapors when heated above the flash point temperature that can
ignite when exposed to a source of ignition. In enclosed spaces, vapors can ignite with
explosive force. Mists or sprays may burn at temperatures below the flash point.
Special Properties
SECTION 5. FIRE FIGHTING MEASURES
Upper Flammable Limit
No data.
SECTION 6. ACCIDENTAL RELEASE MEASURES
Do not touch damaged containers or spilled material unless wearing appropriate protective
equipment. Slipping hazard; do not walk through spilled material. Stop leak if you can do so
without risk. For small spills, absorb or cover with dry earth, sand, or other inert
non-combustible absorbent material and place into waste containers for later disposal.
Contain large spills to maximize product recovery or disposal. Prevent entry into waterways or
sewers. In urban area, cleanup spill as soon as possible. In natural environments, seek
cleanup advice from specialists to minimize physical habitat damage. This material will float
on water. Absorbent pads and similar materials can be used. Comply with all laws and
regulations.
Take proper precautions to ensure your own health and safety before attempting spill control or clean-up. Fo
r
more specific information, refer to the Emergency Overview on Page 1, Exposure Controls and Personal
Protection in Section 8 and Disposal Considerations in Section 13 of this MSDS.
SECTION 7. HANDLING AND STORAGE
Continued on Next Page
Page Number: 3
MSDS No. Revision Date
6/15/2009
625478416